Site work for a water / sewer project in Park Forest, Illinois. Completed plans call for site work for a water / sewer project.

Tank Information: The structure is a 500,000 gallon spheroid elevated water storage tank with an estimated high-water level of 115 ft. located at 375 Indianwood Boulevard in Park Forest, Illinois. The work includes: Exterior: High pressure water clean (5,000 to 10,000 psi) and spot power tool clean to a SSPC-SP11 standard. Apply a three (3) coat epoxy urethane system. Wet Interior - Alternate: Abrasive blast clean to a SSPC-SP10 near-white metal standard. Apply a three (3) coat zinc epoxy system. Apply a polyurethane caulk to the roof lap seams. Foundation: Repair grout, repair cracks, repair spalls. Water clean and apply a two (2) coat epoxy system. Cathodic Protection: Repair/replace the wet interior components of the cathodic protection system. Mixer: Install a mechanical mixer. Catch Basin: Install a concrete catch basin at the overflow pipe discharge. Repairs: Replace the riser manway gaskets. Overflow discharge modification. Install a fall prevention device on the wet interior ladder. Install a swing gate at the roof step-off platform opening. Install bowl rigging couplings. Remove abandoned lights on the struts. Remove the pressure sensor on the riser. Remove the inner painter's railing. Install painter's railing stand-offs on the outer painter's railing. Balcony drain holes. Balcony access modification. MISCELLANEOUS Due to supply chain issues, the Owner reserves the right to require that the Contractor is to have all of the required coating for the project delivered to the site or to the Owner's storage facility prior to the tank being taken out-of-service and commencement of the project. For further requirements regarding bid submittal, qualifications, procedures, and contract award, refer to the Instructions to Bidders, and if applicable Supplemental Instructions to Bidders, that are included in the Bidding Requirements. Note l: The Engineer assumes no responsibility to supply Builders Exchanges and similar plan review rooms with all addenda issued. An attempt will be made to do so; however, only registered plan holders will be notified by email of expected or late term addendum with short preparation times. Note 2: Prequalification of BIDDERS - Dixon Engineering will review qualifications of all Contractors and determine their status. Contractors will be prequalified for different sized tanks and towers based on experience, workmanship, successful Project completions with DIXON and Contractor's financial data. Prequalification protocol is in the Instructions to Bidders. Any Contractor who has any projects in dispute or unfinished because of Contract problems will be considered NOT prequalified. Disqualification will result in the return of any handling fee for Bidding Documents. This contract is subject to prevailing wage requirements. No less than the prevailing wage as determined by the Illinois Department of Labor shall be paid to any worker performing work under this contract. Bidder is to submit all questions about the meaning or intent of the Bidding Documents to DIXON in writing. Contact information and submittal procedures for such questions are to be made to the Issuing Office.