Renovation of an educational facility in San Marcos, Texas. Completed plans call for the renovation of a educational facility.

Properly submitted Proposals will be opened publicly and read aloud pursuant to section 51.782 of the Texas Education Code after the HUB Subcontracting Plans are received and confirmed by the Owner. These readings will be conducted at Texas State University-San Marcos office conference located at: Mail, Courier or Hand Deliver Proposal to: Texas State University ATTN: Michael Maldonado Office of Facilities Procurement & Contracting 151-4 East Sessom, Facilities Warehouse Bldg, Room 110 San Marcos, TX 78666-4616 Submit (1) copy of the Base Proposal and Alternate (if applicable) 1.5.2.2 Submit (1) copy of the Qualifications. 1.5.2.3 Submit one (1) complete electronic copy (i.e., Qualifications, HUB Plan, Base Proposal/Alternate) on USB Flash Drive. POINT-OF-CONTACT: The Owner designates the following person as its representative and Point-of Contact for this CSP. Respondents shall restrict all contact with the Owner and direct all questions regarding this CSP, including questions regarding terms and conditions, to the Point-of-Contact person. All inquiries regarding this CSP must be made in writing. Responses to all inquiries will be answered through the issuance of addenda by the Owner. Buyer Name: Michael Maldonado Title: Buyer III Address: 151-4 East Sessom, Facilities Warehouse Bldg., Room 110 City, State, Zip Code: San Marcos, TX 78666 Phone Number: 512-245-8488 Email Address: mm87@txstate.edu The SOW for the LBJSC Roof Repairs includes: a) Perform pre-installation Infrared Scan of the roof. b) Plug roof drains before water test to check for membrane leaks. Water test all roof drains afterwards to check for any drain line obstructions or leaks. Water source provided by designated University representative. c) Remove and properly dispose of all flashings and sheet metal. d) Properly prepare the existing roof membrane per new Manufacturer's Warranty requirements. e) Apply asphalt primer to the prepared roof surface. f) Torch-apply one (1) layer of Johns Manville DynaWeld Base sheet, or other Vetted Roll Roofing Manufacturer found in the TXST University Campus Construction Standards, in accordance with the Manufacturer's specifications. g) Torch-apply one (1) layer of Johns Manville DynaWeld RED FR Cap sheet, or other Vetted Roll Roofing Manufacturer found in the TXST University Campus Construction Standards, in accordance with the Manufacturer's specifications. h) Install new 24-gauge galvanized metal vent base flashings in place of existing metal vents. i) Install new lead boots at existing sewer vent pipes. j) Fabricate and install new 24-gauge pre-finished (Standard Colors) metal edge and coping cap to match existing profiles. k) Perform final water test of all interior drains. l) Perform post-installation Infrared Scan of the roof. m) Upon Satisfactory completion of the roof, provide the Manufacturer's twenty (20) year Warranty and two (2) year Contractor's Labor and Material Guarantee. n) Provide pedestrian protections o) Provide dumpster and necessary equipment. p) Responsible for clean up and haul off of all trash and construction debris. Any debris generated by this project will be cleaned up daily and hauled away promptly. q) If additional demo needed, JOC will: Replace wet insulation (up to 2" thick) Replace wood nailers (2x6) This proposal should be based on a total roof area of approximately 64,738 square feet. r) No more roofing will be torn off than can be replaced and dried-in daily.