Site work for a clubhouse / community center in Hazard, Kentucky. Completed plans call for site work for a clubhouse / community center.

Plumbing improvements include installation of four new electric water heaters, new panel boards and circuits for emergency power. A new potable hot water recirculation loop will be installed throughout the building and heat trace will be deactivated. Installation of a new emergency water distribution system with self-priming pump will deliver non-potable water to selected janitor mop sinks throughout the building. 074-CAV5-EK15-00 PID- RFB-785-2400000383 Question Deadline 02/23/2024 All questions regarding the meaning or interpretation of the bidding documents shall be directed in writing to the purchasing officer. Unless otherwise specified in the Solicitation, questions received less than ten (10) calendar days prior to the date for receipt of bids may not be answered. The following applies to all products provided this project: (1) All iron and steel used in the project shall be produced in the United States. This means all manufacturing processes, from the initial melting stage through the application of coatings, occurred in the United States. (2) All manufactured products used in this project shall be produced in the United States. This means the manufactured product was manufactured in the United States, and the cost of the components of the manufactured product that are mined, produced, or manufactured in the United States is greater than 55 percent of the total cost of all components of the manufactured product, unless another standard for determining the minimum amount of domestic content of the manufactured product has been established under applicable law or regulation. (3) All construction materials shall be manufactured in the United States. This means that all manufacturing processes for the construction material occurred in the United States. Domestic Hot Water Heater Controls: Provide and install a new DDC controller manufactured by Automated Logic Provide and install an On / Off wall switch for sequence activation. Label as specified Command of pumps CP-1, CP-2, CP-3, CP-4 Command and status of control valves V#1, V#2, V#3, V#4, V#5 V#6 (Valves provided by EMCOR, installed by others) Command of new electric water heaters WH-1, WH-2, WH-3 WH-4 and existing boilers EX B-1, EX B-2 EX B-3 EX B-4 per sequence of operation Monitor water temperatures as specified. (Thermowells provided by EMCOR, installed by others) Monitor potable water pressure (Sensor provided by EMCOR, installed by others) The price for the above stated scope of work is: Forty five thousand nine hundred ninety six dollars ($45,996.00)