Renovation of a residential development in Tacoma, Washington. Completed plans call for the renovation of a residential development.

DESCRIPTION OF HOME INTENT OF REPAIR: Repair water damaged bathroom floor in area approximately 8' X 12'. RESIDENCE TYPE: Double-wide Mobile Home YEAR BUILT: 1985 HOME SQ FT: 1,232 LOCATION: Puyallup Contractor to remove all fixtures and appliances from the affected area. Remove finished surface and cut away compromised or damaged underlayment as needed. Restore all framing, subfloor, and underlayment to original condition and current code and prep underlayment for finished surface treatment and resetting of fixtures or appliances. Remove old flooring as needed and inspect floor condition. Surface should be flat with a maximum difference between adjacent high and low points of 3/16 of an inch in a 10-foot radius and must be clean. Fill excessive voids or low points with a Portland cement based leveling compound (e.g. Ardex) and let dry. If laying over concrete, use 6-mil polyethylene with a minimum 8" lap as a moisture barrier. Figure square footage and add 10%. Acclimate material in the room to be installed a minimum of 48 hours. Provide and install 1/8" sound foam under application. A 1/4" expansion space must be provided around the perimeter of the room. Fixed objects such as door jambs and casings must be undercut. The expansion space in wet rooms needs to be completely filled with a 100% mildew resistant silicone to prevent water getting underneath the floor in the following areas: Bathroom perimeter; In front of kitchen appliances, sink, utility appliances; and All exterior doors. Apply 1/4 round, base, stair nose, carpet transitions, and hard surface reducers per manufacturer's specifications. Question Submission Deadline:May 3, 2023, 2:00pm