Demolition, site work, paving and new construction of a bridge / tunnel in Medina, Ohio. Conceptual plans call for the demolition of a bridge / tunnel; for the construction of a bridge / tunnel; for site work for a bridge / tunnel; and for paving for a bridge / tunnel.

The Medina County Highway Engineer is soliciting statement of qualifications for design services for the preparation of bid and construction documents for the Wall Road Bridge Replacement Project (T.H. 145, Bridge No. 3). This project will be part of the Federal/State Exchange Program that will be administered by the County as an ODOT local-let LPA project. Only Engineers on ODOTs current pre-qualified list for the following Engineering Services will be considered;Y Roadway, Non-complex Design Y Right-of-Way Plan Development, Limited Y Bridge Design, Level 1 Estimated Construction Cost: $770,000 Scope of Services: The project shall be designed in accordance with current ODOT Location and Design Manual. The design and plans for the bridge will be prepared in accordance with the current edition of the ODOT Bridge Design Manual. The county has soil borings and a geotech report on file from the year 2022. The proposed structure will be 28 feet wide (two 10 foot lanes and a 4 foot guardrail offset). Abutments will be replaced. The existing structure is a single span Steel Beam bridge with a steel pan deck with an asphalt wearing surface, 16.0 feet wide and 56 feet long. The existing structure is supported on bridge stone abutments, and spans the River Styx. The proposed bridge will be on a tangent alignment at the existing location. The vertical alignment will be the same as the existing. The County is considering only single span designs using either steel beams or concrete box beams, both with integral concrete decks, for the replacement of the structure. The new roadway pavement will be 20 feet wide with 6 feet graded shoulders. The new roadway should be tapered to meet the existing pavement and roadway width at a 25 to 1 rate. The project is expected to include about 400 feet of work including the bridge. Consultant must demonstrate past experience with dealing with bridge design that spans an active river. Additional information on project scope, submittal requirements and scoring criteria for the Statement of Qualifications can be found on the County Engineers Selection Procedures: The County Engineer will rank consultants based on the Statement of Qualifications. The County Engineer may select a consultant based on the Statement of Qualifications, or select two to three firms to interview. The firm with the best qualifications will be invited to negotiate a contract. All questions are to be submitted via email toehollopeter@medinaco.org The method of Contractor Selection has not been Determined at this time.