Demolition and renovation of a military facility in Fairfield, California. Completed plans call for the renovation of a military facility; and for the demolition of a military facility.

1. SCOPE: Supply all material, equipment, and labor necessary to perform all operations in strict accordance with these specifications in this SOW. The contractor is responsible for all required measurements and drawings. 1.1 Hours of normal operations shall be from 0730 to 1630, Monday - Friday, to exclude all federal holidays. All other dates and/or times must be approved by the government. Clean up shall be done daily within these hours, e.g. pick up scraps, vacuum as needed. 2. LOCATION: All work on this project is to be performed at Travis Air Force Base, CA. 3. DESCRIPTION OF WORK: The following outline of the principle features of work does not in any way limit the responsibility of the contractor to perform all work and furnish all materials to do a complete job within the intent and scope of the specifications, sketches, drawings and contract. General construction consists of the following items: 3.1. Contractor shall be responsible for demolition and abatement of existing drywall materials and mold. The contractor will isolate work areas above abatement areas using critical barriers in order to create a negative pressure enclosure. Remove approximately total of 105 sq. ft. of drywall with visible signs of microbial growth and water damage. Remove damaged pipe duct insulation. Clean wall cavities. HEPA Vacuum and wet wipe containment - apply anti-microbial solution. The contractor will provide all labor, equipment and materials to remove approximately total of 105 square feet mold, replace insulation, drywall, texture, prime, and paint (Sherwin Williams 8646, PROMAR 200, ZERO VOC., EG SHELL.) The contractor shall perform an air sample testing prior to the removal of containment. Contractor will coordinate all work with POCs listed below. The contractor will provide OSHA notification for this class mold project. All work shall be accomplished by mold workers. Question Date 5 June 2023 9AM Hours of normal operations shall be from 0730 to 1630, Monday - Friday, to exclude all federal holidays. All other dates and/or times must be approved by the government. Clean up shall be done daily within these hours, e.g. pick up scraps, vacuum as needed. The following outline of the principle features of work does not in any way limit the responsibility of the contractor to perform all work and furnish all materials to do a complete job within the intent and scope of the specifications, sketches, drawings and contract. General construction consists of the following items: Contractor shall be responsible for demolition and abatement of existing drywall materials and mold. The contractor will isolate work areas above abatement areas using critical barriers in order to create a negative pressure enclosure. Remove approximately total of 105 sq. ft. of drywall with visible signs of microbial growth and water damage. Remove damaged pipe duct insulation. Clean wall cavities. HEPA Vacuum and wet wipe containment - apply anti-microbial solution. The contractor will provide all labor, equipment and materials to remove approximately total of 105 square feet mold, replace insulation, drywall, texture, prime, and paint (Sherwin Williams 8646, PROMAR 200, ZERO VOC., EG SHELL.) The contractor shall perform an air sample testing prior to the removal of containment. Contractor will coordinate all work with POCs listed below. The contractor will provide OSHA notification for this class mold project. All work shall be accomplished by mold workers.