Renovation of a municipal facility in Marysville, Washington. Completed plans call for the renovation of a 13,400-square-foot municipal facility.

The Tulalip Data Services Roof replacement project will consist of removal and disposal of Est;13,400 +/- square feet of existing ribbed galvanized steel roof panels contractor to verify, install new metal roof panels throughout, install new plywood roof deck throughout, remove existing underlayment and install new underlayment, remove and install new pipe penetration boots, remove and install flashing throughout to match existing color, remove and install new ridge cap throughout. Questions Due: May 28th 2:00 PM Work includes but is not limited to: 1. Contractor shall remove and properly dispose of the existing roofing system 2. Contractor shall prep the new roof system per the manufactures recommendation. 3. Contractor shall install a minimum of 3/4 " plywood roof deck throughout 4. Contractor shall install water proof breathable underlayment throughout. 5. Contractor shall tape all overlap and seams of the underlayment using the manufactures recommended materials 6. Contractor shall install new roof panels per the manufacture's recommendations. i. New panels shall be Green to match the existing fascia trim and gutters ii. Panels shall be a minimum of 24-gauge ribbed 3/4 " galvanized steel iii. Contractor shall fasten panels with manufactures recommended method and fasteners 7. Contractor shall provide and install all flashing throughout to match roof system color and product will be galvanized steel; to include but not limited to: i. Drip Edge ii. Eave Flashing iii. Gable Flashing iv. Valley Flashing v. Hip Flashing vi. Sidewall Flashing 8. Contractor shall provide and install all caulking where necessary. 9. Contractor shall provide and install all roof penetration boots and flashing where necessary. 10. Contractor will provide safety cones for protection that clearly identifies the contractors work zone to also include signage where necessary. 11. Contractor shall provide adequate protection of existing finishes and completed Work to prevent incidental and or accidental damage caused in the performance of Work performed as a part of this Prime Contract. Protection may include protective coverings (e.g., plywood, cardboard, paper, masonite, etc.), as well as, strict adherence to daily cleaning requirements. Contractor shall provide, maintain and remove any protective coverings installed as a part of this Contract. 12. Contractor shall be responsible to repair to like "new" conditions any and all existing finishes that are damaged as a result of work performed as a part of this Bid Package 13. Contractor shall provide a project schedule for review and approval prior to starting work. 14. Contractor shall abide by OSHA Fall Protection Requirements at all times when working when required Questions should be addressed to: Lukas Reyes Project Manager Quil Ceda Village 8802 27 th Ave NE Tulalip, Washington 98271 lreyes@tulaliptribes-nsn.gov Phone:(360)716-5022 Cell: (360) 631-7996