Renovation of a water / sewer project in Oklahoma City, Oklahoma. Completed plans call for the renovation of a water / sewer project.

Water Resource Recovery Facility Roof Replacement. The Municipal Authority shall consider award of the bid at or after 6:00 pm on December 12, 2023, to the lowest and best bidder meeting specifications. The Municipal Authority may lay the same over to a subsequent meeting for comparison and computation. The Chairman and Trustees of the Midwest City Municipal Authority reserves the right to reject any or all bids. Bid bond or cashier's check in the amount of five (5) percent of the total bid. Modified Bituminous Roof System: 2+1 Configuration Burmastic Composite Ply HT/POWERPly Endure 200 FR Cap Sheet in Premium Type IV Hot Asphalt o Complete tear off of existing roof to expose the concrete/metal decks. o Remove all obsolete skylights, curbs and equipment that have been identified by the owner. o Deck repairs will be made by a square foot unit cost line item on bid form. o Concrete Decks: Install 1 layer of PowerPly HD Base Sheet in the Premium Hot Bitumen Type IV at a rate of 25lbs. per Sq. o Metal Roof: decks as identified (Must Field Verify), Mechanically fasten (16 fasteners per board) Polyisocyanurate to the metal decking. o Using TremPrime WB, or approved comparable product, prime the concrete deck in accordance with the material data sheet application rates. o Starting with a minimum of 1" at the drain bowl, install the 1/4 " on 12" tapered insulation and crickets no less the 1/2 " on 12", and 1/2 " Securock/DenDeck Prime in Premium Type IV Hot Bitumen at a required rate of 30 lbs per sq. o Install two layers of the Burmastic Composite Ply HT in the Premium Hot Bitumen Type IV at a rate of 25lbs per Sq per layer. Starting at the lowest point, install the ply sheets in a shingled application patterning to ensure water doesn't run alongside or against the ply sheets. o Install the POWERPly Endure 200 FR Granular Cap Sheet in Premium Type IV at a rate of 25 lbs per Square. Starting at the lowest point, install the ply sheets in a shingled application pattering to ensure water doesn't run alongside or against the ply sheets. o Heat-weld all laps MB Cap Sheet Laps. Liquid Applied Membrane Installation: Perimeter Flashings/Penetrations/Drain Sumps Install the AlphaGuard PUMA, liquid applied membrane system to all flashings, pipe penetrations, drain sumps. The Work of Project is defined by the Contract Documents and includes, but is not limited to, the following: 1. Removal of existing roofing over the Main Control Building. Installation of a replacement roofing system with a Hot Asphalt Modified Bitumenous built up roofing system and other Work indicated in the Contract Documents. All Questions are to be submitted by Wednesday, November 22, 2023 by 4 PM.