Renovation of a mixed-use development in Kentwood, Michigan. Completed plans call for the renovation of a municipal facility; fire / police facility; library; and fitness / recreation center.

Reference Number 0000336305 The City issues this RFP to seek proposals from experienced and qualified mechanical and electrical contractors for the provision and installation of various related EMRs at various City buildings, such as light fixture upgrades and LED tub upgrades, HVAC control upgrades, etc. Delivery Point City Hall 4900 Breton Rd SE Kentwood, Michigan United States 49508 Question Acceptance Deadline 12/08/2023 02:00 PM EST Questions are submitted online Yes Buyer Preferences, Guidelines & Requirements General Requirements - Installation Required - Insurance Required - Onsite Maintenance Required - Warranty Information Required Bonding Requirements - Bid Bond 5 % - Performance Bond 100 % - Payment Bond 100 % Purchase Type One Time Only- Delivery Date:06/28/2024 The 53,000 square foot facility analyzed in this report is the department of public works building, located in Kentwood, Michigan. The building is home to a variety of uses with the primary use as a warehouse/storage for city maintenance operations. 1.1. HVAC System The building has (4) air handling units with (1) additional make-up air unit. A boiler system and two (2) condensing units provide the heating and cooling to the air handling units. 2. Facility HVAC Improvement Scope - Cabinet Unit Heaters 2.1. Upgrade of controls for existing Cabinet Unit Heaters 1. Provide the time and material needed to upgrade existing CUH's with new temperature sensor and controls for the following: a. CH-1 (Corridor 118) and CH-2 (Sign Shop 113A). b. Integrate existing units with BMS system, controlling to an adjustable space set point of 60F. Unit to disable ifspace temperature exceedssetpoint and enable ifspace temperature is below space setpoint. 3. Facility HVAC Improvement Scope - Co2 Sensors 3.1. Replace Co2 Sensors 1. Provide the time and material needed to replace 6 existing Co2 sensors located in the following rooms with new factory calibrated sensors based on Make/Model or equivalent (Wall Mount X13790422010, VAC02ZONE010, SEN01087). Tie sensors into existing BMS and associated equipment's demand control ventilation sequences. a. Existing Co2 Sensor Locations for Replacement: o RM 137 (x4), RM 102 (x1), RM 108 (x1)