Renovation of a municipal facility in Independence, Louisiana. Completed plans call for the renovation of a municipal facility.

Installation of Electrical At the Region 9 Facility 129 Calhoun Street, Independence, La. Proposals Received After the Specified Time and Date Will Not Be Opened or Rec Recognized. The Tangipahoa Parish Government Reserves the Right to Reject Bids in Accordance With the Law. Scope of Work Tangipahoa Parish Government 15485 West Club Deluxe Road Hammond, LA 70403 2. Install (1) 600A feeder from the new service to building A which includes the following: Reference Detail 1 and Site Plan unless otherwise specified a. Install conduit through ceiling and under canopies from the Building A&E disconnect at the service to Building As electrical area b. Install (1) electrical termination trough to accommodate connections between the 600A feeder and the disconnects and panels listed below c. Install new wire from the service to the 600A distribution location d. Install (1 ) 200A panel with main breaker at the 600A distribution location for future circuits e. Install (1) 200A (150A fused) disconnect with conduit and wire to feed panels A2 and A2A on the east end of Building A f. Replace panels A2 and A2A and connect existing branch circuits to the new panels g. Install (1 ) 200A disconnect at the 600A distribution location and (1 ) 200A disconnect at the A/C for each of the (3) A/C's for this building, this includes conduit and wire h. Install (1 ) 200A (150A fused) disconnect with conduit and wire to feed Building E panel E1 i. Install 60A circuit from panel E1 to Panel E1A j. Replace panels E1 and E1A and connect needed existing circuits to the new panels 1. (1) 2000A Service which includes the following: Reference Detail 3 and Site Plan unless otherwise specified a. Replace the wiring from the Entergy junction box through the CT cabinet to the 2000A main service disconnect b. Add (1 ) set of wires (match existing wiring) from the Entergy junction box through the CT cabinet to the 2000A main disconnect switch to bring this circuit's amperage up the main service disconnect's rating c. Replace the fuses, mechanical lugs and other termination points in the main service disconnect and in the Entergy junction box d. Install (1) termination cabinet (complete with bus bars, mechanical lugs, etc.) behind the main switch (leaving space for a future transfer switch) to accommodate wiring connections between the main service disconnect and the feeder disconnects e. Remove all damaged gear at the service behind the 2000A main service disconnect f. Install the following feeder disconnects including conduit and wire from the termination cabinet to each feeder disconnect i. (1 ) 600A disconnect to feed Buildings A and E (Concrete building, Building A and warehouse, Building E, next to Building A) ii. (1) 400A (fused at 300 amps) disconnect to feed Building B1 (Office Building) iii. (1 ) 400A disconnect to feed Building B2 (warehouse behind and attached to Building B1) iv. (1 ) 400A disconnect to feed Building C (Warehouse behind Building B) v. (1 ) 200A disconnect to feed the Laydown Yard (This is panel C5 located on the edge of Building C) g. Install trough(s) and raceways as needed for the service h. Coordinate Entergy work - Tangipahoa Parish will need to establish a new Entergy account for this service.