Site work for a retail development in Union, Missouri. Completed plans call for site work for a retail development.

The City of Union (city) Will Accept Sealed Bids for the Cost of Purchase and Installation of Approximately 460 Lf of 6-foot-tall Chain Link Fence With Two (2) 20 Lf Vehicle Gate at 628 North Delmar Union, Mo 63084. Tentative Award March 12, 2024 Potential Start Date March 22, 2024 All work will be completed on or before JUNE 7, 2024. Bidder must agree to pay, as liquidated damages, the sum of $500 for each consecutive calendar day thereafter. Question Deadline 02/12/2024 For questions or to schedule a site inspection call Chad Pohlmann, City of Union Parks & Recreation Director at (636) 583-8471. The City reserves the right to accept or reject and/or all bids and waive any technicalities. When awarded contract, the contractor must provide Certificate of Insurance and Agreement signed by the party whom the Contract was awarded, shall within a reasonable period of time signing the Agreement and return to such party an executed duplicate of the Agreement. City of Union, upon signing the Agreement and with a reasonable period of time shall issue the Notice to Proceed. A written Notice to Proceed shall be used with each project. One (1) week prior to beginning work, the Contractor shall notify the City of Union with the tentative schedule. a. References (including but not limited to) 1. ASTM F552 Standard terminology relating to chain link fencing 2. ASTM F567 Standard practice for installation of chain link fence 3. ASTM F626 Specification for fence fittings 4. ASTM F900 Specification for industrial and commercial swing gates 5. ASTM F1184 Specification for industrial and commercial horizontal slide gates 6. ASTM F2200 Specification for automated vehicular gate construction 7. CLFMI WLG2445, Chain link fence wind load guide for the selection of line post and 8. line post spacing 9. Federal specification RR-F-191/3E fencing, wire and post, metal (chain-link fence posts, top rails and braces) b. The fencing and additional material will meet the following requirements: 1. All materials will meet he ASTM standards 2. Approximately 420 LF of 6 foot tall, 9 gauge woven wire (chain link) fence with 2 inch mesh. 3. Posts, Top Rails, Brace Rails and Gate Frames will be standard weight, galvanized, welded or seamless steel pipe. 4. Post Caps will be malleable iron will be designed to fit snugly over post with a minimum projection of 1-1/2 inches below top of posts. Post caps shall be manufactured with a curved top. 5. Eye Tops will be malleable iron designed to fit over line posts, and for through passage of top rail. 6. Expansion Sleeve Couplings for Top Rails will be steel, 6 inches long, designed to fit tightly on inside of rail, fitted with raised center. 7. Rail Ends for Top Rails and Brace Rails will be malleable iron with holes to receive 3/8 inch bolts for securing to rail end bands. 8. Tension Bands and Bands for Securing Rail Ends will be mild steel flats, at least 11 gage x one inch, tension bands in gates shall be 11 gage x 1 inch. Bolts for use with tension bands and rail end bands shall be 3/8 inch x 1-1/2 inches. 9. Tension Bars will be mild steel flats at least 3/16 inch x 3/4 inch. 10. Tension Wire for Installation at Bottom of Fabric will be 6 gauge steel spring wire, conforming to requirements of AISI Steel Products Manual, Carbon Steel Wire, merchant quality, galvanized, soft temper with Type I coating. Wavy type wire is not acceptable. The Owner reserves the right to waive any informalities or irregularities and to reject any or all bids.