Site work for a water / sewer project in Port Orchard, Washington. Completed plans call for site work for a water / sewer project.

West Sound Utility District is seeking a qualified contractor to provide rehabilitation serv-ices, pump and motor replacement for its Well 11. Well 11 is a 12-inch-diameter well located at 2764 Water Lane SE in Port Orchard, Washington 98366. The well was originally completed with 10-inch-diameter screens (20- to 100-slot) from 485520 feet below ground surface (bgs) and a 5-foot tailpipe from 520 to 525 feet bgs. To address sand production issues, the well was reconstructed in 2003 with a 12-/10-inch-diameter sand control sleeve at the top of the original riser assembly and 30- slot, 6-inch-diameter screens (inside the existing 10-inch-diameter screens) filter-packed with 8x12 Colorado Silica. The District reserves the right to reject any bid, any portion of any bid and/or to reject all bids. No bid will be considered unless accompanied by a bid guaranty (certified or cashier's check, surety bond, or postal money order) payable to West Sound Utility District in an amount not less than five percent (5%) of the Bid Questions regarding Contract Documents, or this invitation to bid may be directed to John Tapia at West Sound Utility District at 360-874-5012 or jtapia@ws ud.us. The intent of this contract is to remove the existing pump, perform a pre-redevelopment video inspection, brush the casings and screens, clean out and redevelop the screens, perform a postredevelopment video inspection, and then reinstall the new pump, motor and all ancillary equipment (New sounding tubes and transducer supplied by owner) once cleanout and redevelopment is complete. The cleanout and redevelopment will be a physical approach preferably using surge-and-bail methods accomplished via a cable-tool drilling rig. Alternately, a sufficiently sized pump hoist equipped with a spudding mechanism and a tool stem of sufficient weight to impart energy into the screen on the tool's downstroke may be used if a cable-tool rig cannot set up over the well. Well cleanout and redevelopment shall be performed in accordance with applicable requirements of Washington Administrative Code (WAC) 173-160 and the requirements of these specifications. Where the requirements of these specifications are more stringent, the requirements of the specifications shall prevail, provided that nothing in these specifications shall be construed to require work in violation of the WAC.