Site work and paving for a road / highway in Ottawa, Ontario. Completed plans call for site work for a road / highway; and for paving for a road / highway.

To provide all labour, equipment and materials for the resurfacing of west rural 7. Summary of Work The Following is Provided for Information Purposes Only and is Subject to Change. The Contractor Shall Refer to the Contract Detail Item Listing Sheet D-cp000920-01 for a Complete Scope of Work. * Apply Step Joint as Per R10 Retail on All Applicable Joints* Chainage Used for Reference and is to Be Laid Out by Contractor Using Pickets in Rounding (Minimum Every 250m and at Transition of Strategy) and Transitions May Be Adjusted by the City Based on Field Observations, There Will Be No Additional Compensation for These Requirements. Franktown Rd/perth St From 150m East of Munster Side Rd to 100m West of Meynell Rd (Approximate Length 6740m) Franktown Rd/ Perth St (or 10) From Munster Side Rd (or 45) (Station 0+000) to Meynell Rd (Station 6+990) is a 2-lane Rural Arterial Undivided Road (2rau). The Speed Limit is 80 Km/h. Franktown Rd/ Perth St is a City Bus Route, It is a Truck Route and is Not Identified as a Spine Cycle Route. Accommodation or Detouring Must Be Maintained and Identified in the Traffic Management Plan. The Asphalt Concrete Thickness Varies From 160mm to 440mm With an Average of 276mm. Tie- Ins Will Be as Required by the Contract Administrator. Project Limits West Limit: 150m East of Munster Rd East Limit: 100m West of Meynell Rd Intersection - Tie Into West Paving Limit of Roundabout Project as Shown in Drawing Below. The General Scope of Work is as Follows: Resurface Franktown Rd / Perth St (or 10) Using a Pre-mill & Pulverize Strategy. Silt Fence is to Be Installed on Both Sides of the Guide Rail. Proceed With Safety Edges Except Where a Paved Shoulder is Installed. Pave Shoulders Within Village Limits - Approx. 280m West of Meynell Rd to Meynell Rd. Tie-in to Paved Shoulder Approx. 175m West of the Roundabout Project Limit. The Culverts Located Within the Limits of the Contract Are Noted Below. Prior to Construction the Contractor is to Review Each Location for Water Presence and Install Erosion/silt Control Fencing as Required. If Required, This Will Be 25m of Fencing Installed on Both Sides of the Roadway Unless Otherwise Indicated. Include Pavement Markings on Side Roads at Intersections That Have Been Upgraded From Gravel. Ditching as Required and Indicated by the Contract Administrator. The successful Tenderer shall Substantially Perform the Work as defined in GC1.05 by Friday, the 23rd day of August, 2024 and this shall be the first date used for the calculation of Liquidated Damages as per TC-18 Subsection 1. The successful Tenderer shall Complete the Work as defined in GC1.06 by Friday, the 06th day of September, 2024