Renovation of a playground / park / athletic field in Joplin, Missouri. Completed plans call for the renovation of a playground / park / athletic field.

This Section includes the following scope of work for Leonard & Humphrey Park located in Joplin, MO 1. Removal of existing shingles down to the wood deck. 2. Install synthetic underlayment nailed to wood deck. 3. Install ice and water shield at all eaves and valleys. 4. Install 30 year Architectural Shingle 5. Install new drip edge. 6. Remove and replace deteriorated wood fascia and soffit to match existing. 7. Clean up all roofing trash and run a magnet to pick up nails. ATHLETIC COMPLEX 3301 W 1ST ST.JOPLIN MO. 64801 All inquiries about this project are to be done through the Parks Division. Contact Jason "Jake" Cowen 417-529-2288 or jcowen@joplinmo.org or by writing to the address indicated above. Any proposals received after the specified deadline will be returned to the vendor. The City reserves the right to evaluate all proposals, to reject any or all proposals and solicit again at a later date. The City may waive any irregularities in the proposal or negotiate variances from specifications and make awards that are in the best interests of the City. The City will have final decision in all matters regarding acceptance of proposals and issuance of awards. The City encourages minority and female owned businesses to submit proposals on all City purchases. The wage rates applicable to this project have been predetermined as required by law and are set forth in the construction specifications and are to be considered as a part of this Notice to Contractors. Payment for this project will be made to the contractor after final inspection and approval by the Director of Parks and Recreation. Bidder must be licensed as a contractor in the City of Joplin. The finance director reserves the right to reject any or all bids. PROJECT CONDITIONS A. Weather Limitations: Proceed with installation only when existing and forecasted weather conditions permit asphalt shingle roofing to be performed according to manufacturer's written instructions and warranty requirements. 1. Install self-adhering sheet underlayment within the range of ambient and substrate temperatures recommended by manufacturer.