Site work for a water / sewer project in Groveland, New York. Completed plans call for site work for a water / sewer project.

As of May 1, 2024, this project has not yet been awarded. A timeline for the award has not yet been established. This project involves the installation of approximately 80,000 linear feet of 2-inch, 4-inch, 6-inch, 8-inch and 12- inch DR-18 water main including appurtenances along portions of Barber Hill Road, Hunt Hill Road, Lee Road, Geneseo Road, Morris Road, Gamble Road, Adamson Road, Logan Road, Turner Road, Dantz Road, Bailey Road, Sonyea Road (NYS Route 36) and Groveland Station Road (NYS Route 63). A pump station will be installed on Barber Hill Road. A pre-bid conference will not be held. Each bid must be accompanied by a certified bank check or bid bond from a domestic carrier licensed to do business in the State of New York in the amount of not less than five percent (5%) of the amount of the bid submitted. Security for Faithful Performance: The successful bidder will be required to furnish Performance and Payment Bonds written by firms licensed to do business in New York State, each in the amount of one hundred percent (100%) of the contract amounts in accordance with the provisions of the Contract Documents. The Town of Groveland reserves the right to reject any and all bids and to waive any informalities therein. Question Deadline 04/12/2024 at 5:00 PM ET Only written Requests For Information (RFI) will be accepted. RFI's will be accepted at the office of the Engineer to the attention of David Hardenbrook, Project Engineer via email: dhardenbrook@cplteam.com. If necessary, an Addendum will be issued by 12:00 p.m. (Local Time) on April 16, 2024 from the office of the Engineer. This project is partially funded under the Rural Utility Service as administered by the United States Department of Agriculture Rural Development (USDA RD) and is subject to the provisions of Section 3 of the HUD Act of 1968 as amended and other USDA RD regulations. Prospective bidders should review the USDA RD requirements included in the contract documents. Section 746 of Title VII of the Consolidated Appropriations Act of 2017 (Division A - Agriculture, Rural Development, Food and Drug Administration, and Related Agencies Appropriations Act, 2017) and subsequent statutes mandating domestic preference applies an American Iron and Steel requirement to this project. All iron and steel products used in this project must be produced in the United States. The term "iron and steel products" means the following products made primarily of iron or steel: lined or unlined pipes and fittings, manhole covers and other municipal castings, hydrants, tanks, flanges, pipe clamps and restraints, valves, structural steel, reinforced precast concrete, and Construction Materials. Document note: Partial sets of Bidding Documents will not be available from the Issuing Office. Neither Owner nor Engineer will be responsible for full or partial sets of Bidding Documents, including Addenda if any, obtained from sources other than the Issuing Office. Only Bidders receiving bid documents from the Issuing Office (electronic or printed) will be allowed to submit a bid to be considered for award.