Renovation of a mixed-use development in Jackson, Georgia. Completed plans call for the renovation of a educational facility.

Athletic Lockers and Storage - The Butts County Board of Education is soliciting bids for athletic lockers and storage . Furnishings of all equipment and labor necessary to complete locker installation including: Coaches, Equipment and Athletic lockers, athletic storage, trim and accessories as shown on the drawings and/ or specified herein. All equipment specified shall be supplied by one manufacturer. Related Sections: Concrete or masonry bases, wood furring, blocking, vinyl base cove or trim as may be required are included in other sections of the specifications. The owner reserves the right to reject any and all bids, to waive any informality in bidding, and to award a contract for any part of the work, or the job as a whole. A. Equipment Requirements: Provide lockers as shown on architectural plans and as described herein: 1. Soccer All- Welded Lockers Size: 18" wide x 22" deep x 72" high - ALL STAR LOCKERS Tier: One Tier Location: Two Connected Locker Rooms Quantity: 52 per locker room - 104 total 2. Football All-Welded Lockers w/Shoulder Pad Racks Size: 24"Wide x 22"deep x 72" high - ALL STAR LOCKERS Tier: One Tier Location: Two Connected Locker Rooms Quantity: 42 per locker room - 84 total 3. Athletic Storage Provide storage that will maximize the designated space. Storage needs will be for varsity softball, middle school football, middle and high school track, and middle and high school soccer. CONSTRUCTION: 1. Locker shall be "SUPERIOR ALL-STAR OPEN FRONT FULLY-FRAMED ALL-WELDED ATHLETIC ALL-STAR LOCKERS" as manufactured by List Industries Inc. or approved equal. All lockers shall be factory-assembled, of all MIG welded construction, in multiple column units to meet job conditions. Assembly of locker bodies by means of bolts, screws or rivets will not be permitted. Welding of knockdown locker construction is not acceptable. Grind exposed welds and metal edges flush and make safe to touch 2. Frame / Vertical Side panels: Shall be of 13 gauge 1/2" flattened expanded metal framed by 16-gauge Hollow "T" tubular sections and channel frame members designed to enclose all four edges of the side panel with the entire assembly MIG welded to form a rigid frame for each locker. The channel frame members are welded to the front and rear vertical frame members to create and anchor bearing surface of 1-1/4 inches wide x the depth of the locker at each side panel. Note: Diamond perforated sheet steel or 3/4" expanded metal will NOT be accepted. 3. Integral Frame Locker base: 14 gauge galvanneal formed structural channels are MIG welded to the front and rear vertical side panel frame members to allow placement of locker bottom a minimum 2-3/4" above floor level. Locker bottom shelf located less than 2" above floor level will not be acceptable 4. Flat Tops: Shall be formed of one piece of 16 gauge cold rolled sheet steel and shall be an integral part MIG welded to each vertical side panel frame member and be continuous to cover the full width of a multiple framed locker unit. 5. Hat Shelves and Bottoms: shall be 16-gauge galvanneal sheet steel, have double bends at front and shall engage slots in the Hollow "T" vertical frame members at all four corners and be securely welded to the frame and side. 6. Backs: Shall be 18 gauges cold rolled sheet steel, be continuous to cover a multiple framed unit and be welded to each vertical side panel frame member