Demolition, site work and addition to a water / sewer project in Houston, Texas. Completed plans call for the addition of a water / sewer project; for the demolition of a water / sewer project; and for site work for a water / sewer project.

Construction of Remote Water Well No. 2 Generator Addition which includes, but is not limited to, construction of a new natural gas engine generator with sound attenuated weatherproof enclosure, natural gas line and meter, coordination with commercial gas company for gas service location and requirements, automatic transfer switch, generator concrete slab, automatic transfer switch concrete slab, electrical service rack modifications, duct bank, conduit, wire and all additional items shown on the construction plans or needed for the completely functional lift station. Estimate: $905,000 The deadline to ask questions is 5/14/2024 2:00 PM CST The project is located in Harris County Municipal Utility District No. 183 at 17830 Kieth Harrow Boulevard, Houston Texas 77084. In ample time to permit consideration before reply, submit questions about bidding instruments to the Engineer via www.civcastusa.com. Questions will not be considered after 2:00 p.m., three (3) calendar days prior to bidding. b. Necessary replies will be issued to bidders of record as addenda, which becomes a part of the bidding instruments. Oral instructions do not form a part of the bidding instruments. c. Bidders should contact the Engineer not less than 72 hours before bid opening to secure any addenda that may affect bidding. Only the acceptable manufacturers listed shall be used in determining the BASE BID. The Contractor must include the name of a manufacturer from this list for each item in the tabulation or circle the manufacturer. Failure to do so may disqualify the Bid. This section specifies requirements for construction joints, contraction joints, expansion joints and embedded items for concrete work. Coordinate work of this section with related work of other sections to obtain a proper installation. Review drawings and specifications for additional requirements for joints and embedded items.