Site work for a road / highway in Missoula, Montana. Completed plans call for site work for a road / highway.

This work consists of furnishing surface preparation and applying epoxy pavement lines, words and symbols shown in this contract or as directed in writing by the Maintenance Chief. Contractor will provide all labor, materials, equipment, incidentals, and traffic control necessary to remove current pavement markings and apply in-laid pavement markings per contract information. The Contractor is required to use 3M Stamark Tape High Performance Tape Series 380I ES for symbols/legends and high durable epoxy paint will be required on all stop bars and crosswalks. There will be 4,088 square feet of durable white epoxy paint. This project has previously been milled and will require new milling for the in-laid tape and epoxy paint to the depths of 125 +/- 10 mills. The Contractor is required to install tape to the manufacturer's specifications. There will be an estimated 9,112 square feet of white tape. Removal of the current pavement markings, cleaning of the roadway surface, preparation of the roadway surface and application of the preformed plastic tape pavement markings will be in accordance with the manufacturer's recommendations and in accordance to MUTCD. Work cannot begin until after: July 1, 2024 Work is required to be completed on or before: August 31, 2024 Question Submission Close Date 6/19/2024 2:00 PM MDT Questions or information relating to either specifications or requirements of this solicitation must be asked through electronically. Contractor will provide all labor, materials, equipment, incidentals, and traffic control necessary to remove current pavement markings and apply in-laid pavement markings per contract information. The Contractor is required to use 3M Stamark Tape High Performance Tape Series 380I ES for symbols/legends and high durable epoxy paint will be required on all stop bars and crosswalks. There will be 4,088 square feet of durable white epoxy paint. This project has previously been milled and will require new milling for the in-laid tape and epoxy paint to the depths of 125 +/- 10 mills. The Contractor is required to install tape to the manufacturer's specifications. There will be an estimated 9,112 square feet of white tape. Removal of the current pavement markings, cleaning of the roadway surface, preparation of the roadway surface and application of the preformed plastic tape pavement markings will be in accordance with the manufacturer's recommendations and in accordance to MUTCD. Existing pavement markings will be replaced in kind, unless otherwise directed by the Maintenance Chief. Contractor will provide the Maintenance Chief with a copy of the manufacturer's installation instructions and specifications prior to the preconstruction meeting.