Renovation of a power facility in Miami, Florida. Completed plans call for the renovation of a power facility.

Traction Power Switchgear Replacement Project Phase IV LOCATION OF WORK: A. The location of work to be performed under the terms of this Contract shall be as follows: 1. South Bayshore Dr. between NE 109 Street and NE 110 Street. 2. At NW 25th Street and NW 39th Ave., Miami Intermodal Center (MIC). Estimated Cost: $3,933,000.00 LICENSE REQUIREMENT: General Contractor, General Engineering Contractor and Electrical Contractor Scope of Work: This Project is for the Upgrade and Replacement of the Existing Department of Transportation and Public Works' (Dtpw) Traction Power Substations Direct Circuit (Dc) Switchgear, Annunciator, Supervisory Control Interface Terminal Cabinet (Scitc) Panels and the Upgrade of the Supervisory Control and Data Acquisition (Scada) System at Three (3) Traction Power Substations and One (1) Gap Tie Substation, Listed as: 1) Gap Tie 1 (Gt1) 2) Vizcaya (Viz) 3) Coconut Grove (Cgv) 4) Douglas Road (Drd) All Hardware and Software Necessary to Convert to Fiber as Well as Programming Services is to Be Supplied by the Contractor. The Latest Plc Software is to Be Installed on the Plcs Installed Under This Contract. Experience: This Project Requires Specialized Equipment and License Requirements to Include a State of Florida Electrical Contractor. The Project is Considered a Closed and Interconnected System, Which Requires That the Work Be Completed By the Same Contractor. The Contractor Must Be Able to Pull in a Master Permit. In Addition, the Contractor is Required to Have a Minimum of Three Years of Experience With Ac and Dc Traction Power Systems in a Transit Environment Including Power Cables and Fiber Optic Installation, Termination and Testing, Equipment Installation, Testing and Commissioning for Revenue Service; Have Previously Worked on Traction Power Scada Systems; Configured Siemens Plc Cpus and Siemens Input/output Modules; Verified Profibus Communications Between Plc and Sitras Pro Dc Protective Relays; Programmed Siemens Scalance Network Switches; Programmed Siemens Ladder Logic, Software Blocks and Hardware Tables; and Worked With a Test Plan to Verify All Commands and Indications at Central Control. Additional Qualifications: 1) Electrical Contractor (Primary) 2) a Minimum of 3 Years of Experience With Ac and Dc Traction Power Systems in a Transit Environment Including Cabling, Installation, Testing and Commissioning for Revenue Service. 3) Previously Worked on 700 Vdc Switchgear. 4) Previously Worked on Traction Power Scada Systems. 5) Configured Siemens Plc Cpus and Siemens Input/output Modules. 6) Verify Profibus Communications Between Plc and Sitras Pro Dc Protective Relays. 7) Programmed Siemens Scalance Network Switches. 8) Programmed Siemens Ladder Logic, Software Blocks and Hardware Tables. 9) Work With a Test Plan to Verify All Commands and Indications at Central Control. 10) Fiber Optics Installation, Termination, and Testing. If you have any questions, contact Marco Movilla at (305) 375-3267. Anticipated Start Date: 9/18/2024 ; Project Completion- 730 Calendar Days