Interior Painting of All Classrooms in Elementary Portion of the Building.
: Springfield International Charter School, 160 Joan St, Springfield, MA
Estimated Cost $60,000 The estimated timeframe to complete this project is between 06/26/2024 and 08/16/2024 A. Deviations from this Specification must be approved in writing by SICS' Director
of Operations prior to the Contractor beginning work.
B. The construction shall be conducted in accordance with applicable regulations and these
Specifications. A general description of the work to be performed shall include but not be
limited to:
1. Spot clean walls.
2. Scrape peeling/chipping paint.
3. Sand localized failures.
4. Spot prime localized failures.
5. Repair holes in wall.
6. Caulk cracks as necessary.
7. Remove outlet covers.
8. Using airless sprayers, brushes, or rollers, complete paint coverage of (36)
classrooms, hallways, and door trim in elementary school.
o Completed classrooms will be finished in 3 colors in the same
pattern as existing classrooms.
o Walls will be covered using Pre-catalyzed Water Based Epoxy
Semi-gloss (Sherin Williams or acceptable substitute)
o Door trim will be covered using a two-component zero VOC
water-based epoxy (Sherwin Williams or acceptable substitute)
C. Pre-bid inspection to be held at the date and time specified above. It is HIGHLY
RECOMMENDED that the potential Bidders visit the site prior to bidding in order to
determine the actual field conditions including access, evaluation of the work areas; and
protection requirements.
D. Contractor shall submit copies of all applicable Safety Data Sheets (SDS) for materials
brought to the SITE shall be reviewed and approved in advance by the SICS Director
of Operations.
E. Contractor shall be responsible of:
1. Coordination with SICS Director of Operations for the protection of existing
utilities including, but not limited to gas, water, sanitary, and electric within the
Limits of Work.
2. Mobilization to the SITE.
3. Installation and maintenance of all protective measures for the duration of theWork
to isolate the work area. Protective measures shall include, but not be limited to
barriers, signage, and caution tape, as required by the SICS Director of Operations.
F. It is the Contractor's responsibility to determine the most efficient method to legally
perform this Work. Unless expressly noted, this Specification does not dictate specific
methods to be implemented in the performance of the Work.
.webp)
