Site work for a water / sewer project in Little Rock, Arkansas. Completed plans call for site work for a water / sewer project.

Tank 17a - 250,000 Gallon Elevated Welded Steel Spheroid Potable Water Storagetank 50 Chenal Heights Drive,little Rock, Ar Central Arkansas Water Project No. 5498 Job No. 09231 Central Arkansas Water Tank 22 - 1m Gallon Elevated Welded Steel Double Elipsoidal Potable Water Storage Tank 1316 Kierre Drive, North Little Rock, Ar Central Arkansas Water Project No. 5549 Job No. 09230. Direct Any bid Questions To Tom Wray Of Central Arkansas Water At (501) 377- 1221 Or Atthomas.wray@carkw.com. All Bids Must Be Accompanied By A Certified Check Or Bid Bond in An Amount Equal To At Least 5%Of The Total Bid. The Commission Reserves The right To Waive Formalities, Reject any Or All Bids, And To Accept The bid Deemed To Serve The Best Interest Of Central Arkansas Water. 1) Interior (wet side) and exterior painting -tank will be drained and temporarily removed from service during the painting work. 2) Discuss pay item for utilizing a containment system around the tank - will need to work around cell facility equipment pads. 3) Interior dry side painting, including interior of access tube. 4) Pay item for steel repair using welding and plate steel. 5) Contract time is 150 consecutive calendar days. The window ofwork is between November 15,2024, and April 15,2025. It is more important to have the Tank 17A work progress ahead ofthe Tank 22 work. Tank 17A should be placed back in service ahead of Tank 22 being placed back in service. 6) Remove existing 12" vents and replace with new 24" vent. 7) T-Mobile, Verizon and AT&T have facilities on the tank but will temporarily relocate to COW's to be located on the tank site. The contractor may have to work around some cables and equipment. 8) Replace over-fill outlet assembly. 9) Replace 6" drain valve. 10) Replace roof hatch gasket. 11) Core-drill additional 4" holes through splash pad concrete wall. 12) Cut-in 1" swing check valves in 1" drain pipe running from platforms to tank drain pipe. 13) Install safety-climb assembly on tank bowl ladder. 14) Replace any damaged or cut screening. 15) Remove existing corrosion protection system. 16) A tank mixer will be installed by Instrument Supply before the tank is placed back in service. The contractor will accommodate and coordinate this work with CAW and Instrument & Supply