Renovation of a water / sewer project in Fond du Lac, Wisconsin. Completed plans call for the renovation of a water / sewer project.

SCOPE OF WORK Materials, Equipment, and Labor for the installation of a Fluid Engineering Series 751 Hyper-Jet Self Cleaning Strainer Question Deadline 07/25/2024 at 12:00 PM CT Inquiries regarding this Request for Bids will be accepted via E-mail only, addressed to Cameron Fails, at cfails@fdl.wi.gov. Unauthorized contact regarding the RFB with other City of Fond du Lac employees may result in disqualification. Scope Bidders should familiarize themselves with the attached specifications. Reference to Fluid Engineering equipment is for reference only, and any OR EQUAL bids will be considered The City also reserves the right to waive any formalities or informalities in bidding, and to select the bid that, in its opinion, will best serve the interests of the City. Automatic Strainer Installation Labor, Equipment, and Materials to perform the following: -Install mounts for new strainer and any additional concrete work -Modify existing piping to accommodate the new strainer with 8" 304 SS piping and fittings -Install backwash piping to existing drain with sch 40 PVC piping -Includes new SS hardware, Dezurik valves and gaskets -Excludes electrical installation of the control panel and wiring of electric motor and control valves -Manual strainer to remain in place New Automatic Strainer FLUID ENGINEERING SERIES 751 HYPER-JET(R) SELF-CLEANING STRAINER HOUSING MATERIAL: A126 GRADE B CAST IRON BACKWASH ASSY: STAINLESS STEEL O-RING MATERIAL: BUNA-N COATING/LINING: RED-OXIDE PRIMERED EXTERIOR INLET/OUTLET CONN: 8"-125# FF FLANGED BACKWASH CONN: 1-1/2" NPT EXTERNAL SOURCE CONN: 1" NPT DRAIN CONN: 1" NPT VENT CONN: 1/4" NPT INST CONN (2): 1/4" NPT DESIGN; 150 PSIG@150F SCREEN ASSEMBLY FOR SELF-CLEANING STRAINER FITS 8'710" SERIES 700 FLUID ENGINEERING STRAINER 0.007" (175 MICRON) SLOTTED REVERSE-ROLLED WEDGE-WIRE CONSTRUCTION316LSTAINLESS STEEL 1/4 HP ELECTRIC MOTOR 115/208-230 VOLT 1PH 60HZ TEFC ENCLOSURE CLASS B INSULATION CONTROL PANEL WORKS WITH FLUID ENGINEERING HYPER-JET(R) SELF-CLEANING STRAINER ELECTRICAL REQUIREMENTS: 120 VOLT SINGLE PHASE 60HZ NEMA 4X STAINLESS STEEL ENCLOSURE RESET BUTTON ON DOOR FOR MOTOR OVERLOAD FUSIBLE MAIN DISCONNECT SWITCH WITH J TYPE FUSE SQUARE D GK6 TERMINAL BLOCKS AB MOTOR STARTER AND SOLID STATE OVERLOAD RELAY STANDARD TIMER LOGIC 30MM TYPE DOOR OPERATORS 1-1/2" BALL VALVE WITH ELECTRIC ACTUATOR 1" BALL VALVE WITH ELECTRIC ACTUATOR DIFFERENTIAL PRESSURE SWITCH