Site work and new construction of a mixed-use development in Tallassee, Alabama. Completed plans call for the construction of a pre-engineered storage facility; for site work for a pre-engineered storage facility; and water / sewer project.

Scope of Work: Gc to Provide the Following: 1) Gc to Visit Site and Verify Location and Site Work. 2) All Permits and Fees Will Beincluded in the Gc Bid Proposal. 3) Gc Shall Purchase and Maintain $5,000,000.00 of Liabilityinsurance. Gc Shall Carry Workers Comp. On All Employees.gc Shall Maintain Builders Risk insurance for the Amount of His bid Proposal. 4) 80' X 120' X 16' Pre-engineered Metal Building With A2/12 Roof Slope. 80' Clear Spans. gutters and Downspouts. No Interior Columns Allowed. 5) Concrete Foundations &structural Design Shall Be Done by a Licensed Structural Engineer and Submitted to the Owner Before Construction Begins.6" Concrete Slab With Weldedwire Mesh. 6) 6" Roof Insulation and 4" Wallinsulation 7) Gc to Provide Concrete Foundation, Building and All Building components Described in Thesespecs. 8) Gc to Provide All Labor And materials Associated With The erection of Building. 9) Anchor Bolts Must Be a Minimum of 18" and Placed in Theconcrete Foundation at the Placing of the Concrete. No Wedgeanchors or Epoxy of Any Kind will Be Acceptable After Concrete Has Been Poured. 10) Designed for Ibc 2021 11) 3 Lb. Collateral Load. 12) Provide Two 16'x14' Commercial Series Roll-up Door Provide One 14'x14' Commercial series Roll-up Door Provide Three 3070-man Doors. 13) Install Floor Drains in Shop bays. Floor Drains Must Be Traffic Grade Drains. 14) Finish Out 1000sf of Conditioned Office Area With Shower, urinal and Water Closet. Furnish drawing for Owners' Approval before Construction. 15) Provide 400-amp Electric alse rvice for Buildings With Ledlig hting and Convenience 110plugs. All Electrical and Lighting must Be by Code and in Metal conduit. Provide Six 300 Watt Led Floodlight on 6 Poles. One on Eachpole Provide One 300 Watt Led Floodlight on Each Side of the Building. Provide One 48-inch Box Exhaust Fan. Minimum of 18000cfm. Provide One 52-inch Wall Mounted Gravity Damper Double Panelshutter With Pull Chain. Provide Two 220 Volts Plugs As determined by the Owner. 16) Provide Approved Septic system 17) Provide 1750 Lf of Fencingfor 4 Acres. 6' Tall Commercial chain-link With Razor Wire Above.2-12'x 12' Gates. One 20' Automatic Rolling Gate With Key Paidentry. 18) Provide a 30' X 35', 6"concrete Pad in Front of Roll-up doors. 19) Provide 3 Sets of Engineer or Architect Stamped Design And construction Drawings Including Site, Structural, Foundation, electrical, Plumbing, and Other trades as Necessary. Certification: Submit Writtence rtification and All Structural Calculations Prepared And signed by a Professional Engineer, Registered to Practice In the State Where Building is to Beerected, Verifying That Building design Meets Indicated Loading Requirements and Codes Of authorities Having Jurisdiction. calculations Shall Clearly Showall Loads Used for the Design Of each Member. All Column Reactions at the Foundation Shall Beprovided for Verification of The foundation Design. Manufacturer's Qualifications: Provide pre-engineeredmetal buildings as producedby a manufacturer with notless than 5 years' successfulexperience in the fabrication ofpre-engineered metal buildingsof the type and quality required.The manufacturer will be amember of the MBMA