Renovation of a fire / police facility in Modesto, California. Completed plans call for the renovation of a fire / police facility.

The Stanislaus County Sheriff's Department (County) is seeking bids from qualified and experienced Contractors with valid C-10 Electrical contractor's license and current DIR registration numbers to provide electrical and conduit services for the new welding project located at the horse stalls adjacent to the K9 building . The Stanislaus County Sheriff's Department (County) is seeking bids from qualified and experienced Contractors with valid C-10 Electrical contractor's license and DIR registration to perform the Work described in Part II, Exhibit A at the horse stall adjacent to 450 E Hackett Rd. Modesto CA. Duration- The Contractor must achieve Substantial Completion within 45 days ; The Contractor shall achieve Final Completion within 15 days after Substantial Completion. Project Type Bid Response Types Line Items Bid Bond Bid Response / Documentation Type of Award Lump Sum Categories 238210 - Electrical Contractors and Other Wiring Installation Contractors Bid Bond Bid Bond 10.00% Payment Bond 100.00% Performance Bond 100.00% Question Deadline 08/06/2024 at 5:00 PM PT Online Q&A Yes Contact Info Yer Tapia 209-525-4382 TapiaY@stancounty.com Excludes: EMT conduit, fitting, support, wire, lighting fixtures, and devices. Phase Two (2): o Provide 800Amp power from secondary side of existing DRC, TID transformer to 800Amp Fuse Disconnect by undermining CMU wall and trenching parallel to wall out to location near barn, exact location to be shown on job walk. o Power to feed 800Amp, 240Volt fuse disconnect. o Disconnect to feed 100Amp Panel "K9" in new programs yard and 600Amp Panel "Barn1A" for new welding site inside covered barn (old horse stall area). o 600Amp Barn Panel to feed 100Amp sub-panel as well as step-up transformer from 120/208v to 277/480v to welders and compressor from 600Amp barn panel. o From 100Amp "Barn1B" sub-panel (all on Phase-2) o EMT stubs, convert from PVC to EMT for all connections. o Mount all power gear and light fixtures. o Run all EMT to junction box locations. o Pull all wire and terminate. o Install devices (receptacles, switches, and disconnects). o (25) 120v receptacles inside barn coming out from 100A sub-panel "Barn1B". o (21) 120v quad- receptacles for inside Conex boxes (3 in each 40ft and 2 in each 20ft). o (7) 8' Vapor Tight LED Light Strips over welding booths. o (14) 8' Vapor Tight LED Light Strips for rest of barn area. o (26) 8' Vapor Tight LED Light Strips inside Conex boxes (4 in each 40ft and 2 in each 20ft) Location to be determined. o (4) 120/208v, 150w LED Flood Lights with 2-bull horn brackets, 2-per light and with motion sensors for programs yard area. o (2) future stub-ups for future lighting under new awning on the north side of barn. o (8) single-pole switch inside each Conex box to control lighting. o (3) switches with motion for lighting under barn area (front, side and middle location). o All electrical equipment shall be outdoor rate. o All underground conduits feeders shall be PVC-40.