Remodeling of a fitness / recreation center in Florence, Alabama. Completed plans call for the remodel of a fitness / recreation center.

A certified check or bid bond payable to the City of Florence in an amount not less than five (5) percent of the amount of the Bid, but in no event more than $10,000, must accompany the bidder's proposal. Performance and Payment Bonds and evidence of insurance required in the bid documents will be required at the signing of the Contract. Bids must be submitted on proposal forms furnished by the Architect or copies thereof. All bidders bidding in amounts exceeding that established by the State Licensing Board for General Contractors must be licensed under the provisions of Title 34, Chapter 8, Code of Alabama, 1975, and must show evidence of license before bidding or bid will not be received or considered by the Architect; the bidder shall show such evidence by clearly displaying his or her current license number on the outside of the sealed envelope in which the proposal is delivered. The Owner reserves the right to reject any or all proposals and to waive technical errors if, in the Owner's judgment, the best interests of the Owner will thereby be promoted. Description of Work: A. This section of the specifications is coordinated with and complimentary to certain sections of the General Specifications. Specifically, the Contractor shall refer to "Instructions," "General Conditions," "Special Conditions," and all other relevant divisions of work. Applicable provisions of the General Conditions shall govern work under this heading as if written in full herein. B. The Electrical Specifications shall be all inclusive in their individual divisions of work and shall refer to and be a part of all applicable parts of the General Specifications whether bound with these Specifications or whether handled as a separate document. C. These Specifications are intended to provide for a complete electrical system. Any item(s) indicated on the Drawings and not specified or vice-versa, or any detail omitted which is necessary for the proper installation of the system, shall be supplied and installed by the Contractor without additional cost. D. The Drawings and Specifications shall be considered complimentary one to the other so that materials or labor indicated, called for or implied by one and not the other shall be supplied as though called for by both. E. The Electrical Contractor shall keep clean plans on the job and mark all changes (changes by addenda, change orders, re-routing of conduits or circuits to meet field conditions, etc.) made in the field. These changes shall be marked on the plans when they are made and not when the job is finished. This set of plans shall be turned over to the Architect or the Engineer through the General Contractor to be included in asbuilt plans