BLOCK PAGE!!!

Subscribe For Access

Privately Funded

Bidding Soon

Documents Available

Publicly Funded

Addenda Available

Post-Bid

Saving Project...

This is a service / maintenance or supply contract in Sanford, Florida. Contact the soliciting agency for additional information.

Summary The Contractor shall provide all labor, materials, hardware, equipment, supervision and permits necessary to complete the work as specified in the scope of services for the inspection, testing, calibration, and repair of Backflow Prevention Assemblies (BFPAs) at designated locations. All work must be accomplished during normal business hours unless approved by Facilities Management staff. 1. Introduction The Bidder is expected to completely analyze the information contained in this Invitation for Bid (IFB) as guidance for the preparation of their written submittal. The Bidder's written bid should be specific, detailed, and complete to demonstrate the Bidder's understanding of the requested work clearly and fully and/or delivery requirements. 1.1. Summary The Contractor shall provide all labor, materials, hardware, equipment, supervision and permits necessary to complete the work as specified in the scope of services for the inspection, testing, calibration, and repair of Backflow Prevention Assemblies (BFPAs) at designated locations. All work must be accomplished during normal business hours unless approved by Facilities Management staff. 1.2. Contact Information Leticia Figueroa Senior Procurement Analyst 1301 East Second Street Sanford, FL 32771 Email: lfigueroa@seminolecountyfl.gov Phone: (407) 665-7119 Department: Public Works - Facilities Management Question Submission Deadline: November 25, 2024, 10:00am 2. Scope of Services 2.1. PROJECT DESCRIPTION I. GENERAL. The Contractor shall provide all labor, materials, hardware, equipment, supervision and permits necessary to complete the work as specified in the scope of services for the inspection, testing, calibration, and repair of Backflow Prevention Assemblies (BFPAs) at designated locations. All work must be accomplished during normal business hours unless approved by Facilities Management staff. II. SCOPE OF WORK. A. The Contractor will perform inspections, testing, calibration, and all necessary repairs required for certification of the BFPAs (2) inches and smaller. B. The Contractor will perform inspections, testing, and calibration of all BFPAs larger than (2) inches. C. All necessary repairs for BFPAs larger than (2) inches, up to and including (4) inches shall be billed in accordance with the blended repair rate set forth in the attached price schedule. All necessary repairs for BFPAs larger than (4) inches shall require a detailed written quote. Facilities Management is not required to use the successful bidder for repairs on BFPAs larger than (4) inches. D. Contractor shall comply with all current applicable requirements established by Cross Connection Programs (CCPs), Florida Department of Environmental Protection (FDEP), and Florida Building Code or latest edition standards, Federal, State and Local laws, rules, regulations, permits, codes, ordinances, and State Statutes which govern this type of service. In case of conflict between authorities having jurisdiction the most stringent requirement shall govern. The contractor's proposal shall reflect the most stringent requirement. E. The Contractor may perform the work using equipment, tools and machinery of his own choosing. Any parts of the County Facilities which are damaged by the Contractor's equipment or procedures during services shall be replaced or repaired as directed by the County at the Contractor's expense. The Contractor shall provide proof of calibration of the equipment used during the course of the services and during the life of this contract. The calibration information shall be on all inspection reports. F. The Contractor shall take necessary precautions to protect personnel or property against injury or damages. The Contractor shall be responsible for any injury/damages that occur as a result of his failure to provide adequate protection. G. Any assistance call deemed an emergency by Facilities Management shall have a contractor representative on site within two (2) hours. III. SCHEDULING AND TESTING. A. The Contractor must submit a schedule to Facilities Management before any inspections can take place. Facilities Management must be notified forty-eight (48) hours before the intended start date. B. Upon completion of a scheduled test and/or inspection of a BFPA larger than (4) inches, Contractor shall provide a list of deficiencies to Facilities Management or designee for review within ten (10) calendar days. All repairs must be approved and a work order number must be issued by Facilities Management before any repair takes place. C. Inspections shall be submitted, at the expense of the Contractor, to the proper Cross Connection Control Program office(s) and to Seminole County Facilities Management in such form as the Florida Department of Environmental Protection prescribes. IV. REPORTING REQUIREMENTS. A. REPORTS: All backflow assembly inspection reports shall include facility address, backflow assembly model and serial numbers, GPS location coordinates of the backflow assembly (accurate within 10 feet), digital time-stamped picture of the backflow assembly at time of test completion, and inspection date. All inspection reports must be made available by the Contractor in an electronic format approved by the various County and City entities enforcing cross connection control as well as the County designee. Contractor must provide inspection reports directly to the various County and City entities enforcing cross connection control for the specific backflow assemblies. B. Authorization for services by the successful Contractor under this Agreement shall be in the form of written Release Orders issued and executed by the County. Each Release Order shall describe the required services and shall state the delivery information.

Sub-Bidding

Water / Sewer

Public - County

Service, Maintenance and Supply

Plans and Specifications are not available for this project. If that changes, they will be made available here.

Subscribe For Documents

2 Record(s)

Subscribe for All Details

Trades Specified

Division 00 - Lorem Ipsum

Division 00 - Lorem Ipsum

Lorem, Ipsum, Dolor, Sit amet

Find More Local Projects

Within 75 Miles of This Project
130
Active Projects
70
Bidding Soon
1,254
All Active Projects
542
Updated Recently

You’ve Reached the Free View Limit

Want to see more project and bidder data in your market? Check out our product options and see what works best for you and your business.

Come back in [[refresh_days]] to get [[project_count]] more free projects.

December 4, 2024

January 3, 2025

img_map_placeholder

Multiple Locations, Sanford, FL

Related To This Project


The data you need to build the relationships you want. Try it free.

Access Now

Get the right
data with Project Intelligence

Share with your network.

Project Shared

with

example@example.com

Upgrade now for industry‑leading commercial construction data.

You've reached the free-view limit.

Thousands of projects are added every week - don't miss out. Explore the best product options for your business and subscribe today.

Get Access Now

Choose what you would like to do.

Seen enough? Want to see more? Subscribe on your own or talk to one of our sales reps.

Fuel growth with access to the bidding project info your business needs.

Full details, including key contact information, important dates, plans and specifications, on over 500,000 Projects including 5000 updated daily available to subscribers.