This is a service / maintenance or supply contract in Glendale, California. Contact the soliciting agency for additional information.

The City Project Manager in charge of this Project is: Kevin C. Todd, Assistant Director of Public Works City of Glendale Public Works Department 633 E. Broadway, Room 307 Glendale, CA 91206 Telephone: 818-548-3970 Email: ktodd@glendaleca.gov additional site visit note: Attendees or their representatives will be required to sign-in at the Job Walk. Check in at Perkins Building Community Room on the 1st Floor. All contractors planning to attend the mandatory Job Walk shall RSVP by 4PM on December 3 by email to bsojobi@glendaleca.gov. The purpose of this Job Walk is to ensure that Bidders have adequate information to respond fully and comprehensively to the City's requirements. During the Job Walk, City staff will discuss with prospective Bidders the Services to be performed and answer questions arising from Bidders' initial review of this IFB. Before the Job Walk takes place, Bidders should review the IFB thoroughly and should be familiar with its content, as well as the City's functional and technical requirements. Contractor shall: o Document all tasks performed during visit and report observations to City representative. o Check with City representative, prior to services being performed, for operational deficiencies. o Perform all work in accordance with City, Contractor, OSHA, NEC, Industry Standard rules, regulations, and safety procedures. o Service and repair all systems and equipment per manufacturer's recommendations. o Remove all extra material and debris from the work site. o Leave equipment and work site clean. o Provide Journey Level technicians that are formally trained, certified, and experienced, with the City's type of electrical systems. o Provide written proposals for all services rendered. o Contractor shall use only Original Equipment Manufacturer (OEM) parts and materials and or compatible parts and materials that are approved by the OEM. Contractor shall provide all labor, materials, and equipment to perform comprehensive electrical services including, but not limited to: o Voltages up to 600 volts o General wiring and cabling o Cable pulling and splicing o Trenching o Boring o Concrete foundations o Switches, dimmers, and outlets (interior and exterior) o Conduit installation (rigid and flex) o Permits o Title 24, including calculations o Booms, lifts, cranes o Electric motors up to 50 horsepower o Generators up to 1200kva o Transfer switches o UPS systems o Circuit breakers and programming o Switch gear and panels o Commercial/ Industrial/ Architectural system o Hazardous environment fixtures: e.g. CNG, sewer, garages, etc. o Post light poles and fixtures up to 35 feet o Light bulbs, lamps, ballasts, lenses o Lighting: LED, Florescent, Halogen, Induction, HID, HPS o Interior, exterior and landscape lighting and electrical o Load balancing o Photometric studies o Exit signs, building signs, marquees o Lighting control panels