Renovation of a municipal facility in Concord, New Hampshire. Completed plans call for the renovation of a municipal facility.

Vendor must examine the conditions under which the ceiling work is to be performed and notify the State in writing of any unsatisfactory conditions. The Vendor shall make sure all unsatisfactory conditions have been corrected before proceeding. Vendor shall supply all labor, tools, transportation, materials, equipment and permits as necessary and required to perform services as described herein. Remove existing ceiling tiles and supply and install 2 x 2 tiles and grid: Approximately a 1,706 sq ft area. Install units in place snugly. Provide spacers or hold-down clips where required. After installation, clean any soiled surfaces. There are no sprinklers or smoke detectors to work around. There are five (5) small puck cameras each secured to a ceiling tile, eleven (11) recessed lights, 2' x 4' each, and one (1) bulb fixture to be aware of. Ceiling tiles should be a class A rating or better. Thickness of ceiling tile should be industry standard, approximately 0.625". Vertical Support System: Suspension wires shall be a minimum of 12-gauge galvanized wire attached to the main runner at 4 ft. maximum spacing in both directions. Each wire shall be anchored to the structure above with a device capable of supporting a minimum of 75 pounds. Wires supporting fixtures shall be capable of supporting four times the fixture weight. Suspension wires shall not hang more than 1 in 6 out of plumb unless counter sloping wires are provided. Wires shall not attach to or bond around interfering material such as ductwork. Trapeze or equivalent devices shall be used where obstructions interfere with direct suspension. Horizontal Support System: The lateral support systems for ceilings shall be shown in detail shop Drawings. Provisions shall be made for possible deferential movement between ceilings and sidewalls. Terminal ends of each main and each cross runner shall be wire supported; wall trim angles shall not provide primary support for runners. Lateral support of ceilings shall not be provided by the angle trim and runner shall not be riveted to wall trim. All recessed or drop-in light fixtures shall be supported directly from the fixture housing to the structure above with a minimum of two 12 gauge wires; leveling and positioning of fixture may be provided by the ceiling grid. Fixture support wires may be slightly loose to allow fixture to seat in heavy[1]duty grid system only. The State of New Hampshire shall have the right to terminate any resultant contract at any time with a thirty (30) day written notice to the successful Vendor. Question Deadline 11/29/2024 States response to questions, clarifications, and/or requested changes to bid: 12/4/2024. Questions shall be submitted by email to Abbie Joy at Abigail.F.Joy@DAS.NH.Gov The award shall be made to the Vendor meeting the criteria established in this RFB and providing the lowest cost in total. The State reserves the right to reject any or all bids or any part thereof and add/delete items/locations to the contract. All award(s) shall be, in the form of a State of New Hampshire Contract. Bid open description: Microsoft Teams Need help Join the meeting now Meeting ID: 278 541 000 421 Passcode: 5kPdeh Dial in by phone +1 603-931-4944,,227785343# United States, Concord Find a local number Phone conference ID: 227 785 343# Join on a video conferencing device Tenant key: nhgov@m.webex.com Video ID: 113 249 320 0 More info For organizers: Meeting options | Reset dial-in PIN