Site work for a water / sewer project in Tigard, Oregon. Completed plans call for site work for a water / sewer project.

The project generally consists of the following (the Work): 1. Mobilization, erosion and sediment control, traffic control. 2. 320 linear feet of 6 inch CIPP liner installation. 3. 2,690 linear feet of 8 inch CIPP liner installation. 4. 870 linear feet of 12 inch CIPP liner installation. 5. 170 linear feet of 15 inch CIPP liner installation. 6. 70 linear feet of 36 inch CIPP liner installation. 7. Service lateral line reconnections. 8. Pipe video inspection. 9. Performance of extra work as called for by the specifications and plans. Basis of Bid Award shall incorporate all items identified on the Bid Schedule. The engineer's estimate is $640,000. Pursuant to Tigard Public Contracting Rule 30.055, all Bidders must submit a Bid security to the City along with their Bid in an amount equal to ten percent (10%) of their Bid. Contractor shall provide proof to the City prior to the beginning of any of the Work that the Contractor has filed a public works bond with a corporate surety in the amount of $30,000 with the Construction Contractors Board as required under Oregon Prevailing Wage Rate (PWR) law. No Bid will be considered unless fully completed in a manner provided in the Bid Packet. Bids received after the Bid Closing will be returned to the submitting firm unopened after a Contract has been awarded for the required services. The City may reject any Bid not in compliance with all prescribed public bidding procedures and requirements and may reject for good cause any or all Bids upon a finding of the City if it is in the public interest to do so. All questions about the meaning or intent of the Bid Documents shall be submitted in writing to the Contracts and Purchasing Department at contractspurchasing@tigard-or.gov. Clarifications to the Bid Documents will be made by addenda only. Oral statements may not be relied upon by Bidders and will not be binding or legally effective. Submittals covered by these requirements include manufacturers' information, shop drawings, test procedures, test results, samples, and miscellaneous Work-related submittals. Submittals shall also include, but not be limited to, all mechanical, electrical and electronic equipment and systems, materials, reinforcing steel, fabricated items, and piping and conduit details. The Contractor shall furnish all drawings, specifications, descriptive data, certificates, samples, tests, methods, schedules, and manufacturer's installation and warranty information and other instructions as specifically required in the Contract Documents to demonstrate fully that the materials and equipment to be furnished and the methods of work comply with the provisions and intent of the Contract Documents. The purpose of the Contract is to set forth the rights and obligations of the parties and the terms and conditions governing completion of the Work. The Contractor's obligations shall include without limitation the following: A. The Contractor shall furnish all Materials, Equipment, labor, transportation, and Incidentals required to complete the Work according to Plans, Specifications, and terms of the Contract. B. The Contractor shall perform the Work according to the lines, grades, Typical Sections, dimensions, and other details shown on the Plans, as modified by written order. C. The Contractor shall contact the Engineer for any necessary clarification or interpretation of the Contract.