Site work for a pipeline in Bryan, Texas. Completed plans call for site work for a pipeline.

Hypersonic Wind Tunnel Vacuum Air Receivers and High-Pressure Pipe Lines, Fabrication, delivery and installation to be included in bid price. Delivery address is Texas A&M RELLIS Campus, Hypersonic Wind Tunnel, 494 RELLIS Parkway Bryan, Texas 77807. Target date for installation is February 2026. All questions and bid responses must be submitted through electronically. Fabrication, delivery and installation to be included in bid price. Delivery address is Texas A&M RELLIS Campus, Hypersonic Wind Tunnel, 494 RELLIS Parkway Bryan, Texas 77807. Target date for installation is February 2026. Item 1: Vacuum Air Receivers (i) Eight (8) 25,000-gal Air Receivers (ASME rated for full vacuum and 100 psi/FV @ 200F, MDMT -20F) Tank dimensions: 120-inch diameter X 40-ft length (shell-to-shell) Shell Cylinder: SA516-70 Heads: SA516-70 Nozzles: SA105 / SA106-B Bottom Vortex Breaker: Included CS Support Saddles: SA-516-70 Lifting Lugs: Included Bolting: SA193-B7/SA194-2H (included) Gaskets: 304SS Spiral Wound Internal Piping: SA-106-B Impact Test: per code requirements ASME Code & NB: Included X-Ray: Per code External Coating: Two (2) coat epoxy Insulation: Not Included Flanged Openings: Six (6) tanks will be fitted with three (3) standard 3-ft diameter flanged openings (2.5 ft long) as shown in the attached drawings. Two tanks will have an additional 5-ft diameter flanged opening (15-ft long) on one end as shown in the attached drawing (or can be a flanged at the tank with a 5-ft diameter,15-ft long pipe section with flanges on each end). This opening should be offset toward the ground such that center of the opening is 5-ft from the ground. Supports: Each tank will have two supports, spaced 424-inch apart as per the attached drawing. Item 2: 24-inch High-Pressure Pipe-Line (i) Fifteen (15) 24-inch diameter pipe sections (Sch 160 OD X 20-ft long) with 900# RTJ flanges welded at each end (rated for 2000 psi) (ii) One (1) 24-inch diameter pipe 180-degree elbow (Sch 160) with 900# RTJ flanges welded at each end (rated for 2100 psi), Can be made from two (2) 90-degree elbows (flanged). Materials of construction: Pipe: SA312-316/316L WELDED PIPE SCH.160 Flanges: SA182-316/316L RTJ 900# Pipe Honing after welding: Included Hydro Test: Included Sugar blasting: Included Gaskets and bolting: Included Item 3: 20-inch High-Pressure Pipe-Line (i) Ten (10) pipe sections (20-inch diameter pipe, Sch 160 pipe X 20-ft long) with RTJ flanges welded at each end (rated for 2100 psi) Materials of construction: Pipe: SA312-316/316L WELDED PIPE SCH.160 Flanges: SA182-316/316L RTJ 900# Pipe Honing after welding: Included Hydro Test: Included Sugar blasting: Included Gaskets and bolting: Included Awarded GC: Houston Vessel Manufacturing, Houston, Texas $5,977,988