Site work and paving for a road / highway in Plymouth Meeting, Pennsylvania. Completed plans call for site work for a road / highway; and for paving for a road / highway.

Each bid must be accompanied by a certified check or bid bond payable to the order of PLYMOUTH TOWNSHIP executed by the bidder and acceptable surety, in an amount equal to ten (10%) percent of the total bid amount. PLYMOUTH TOWNSHIP hereby reserves the right to reject any or all bids submitted, or any portion thereof, and also reserves the right to waive any informalities or irregularities in bids received, when, within the sole discretions of the Township, such rejection or waiver is in the best interests of the Township. *The value for this project is based on a financial range. The value is listed as the highest possible cost from the range provided by a stakeholder or official project document. HFR/js #7375-07-45 7/16/08 The project consists of approximately 9,600 square yards of curbside milling, and approximately 1,850 tons of 1-1/2" Warm mix wearing course asphalt overlay on existing streets; Pub 408 specifications SUPERPAVE ASPHALT MIXTURE DESIGN, WEARING COURSE, PG 64S-22, 0.3 TO < 3 MILLION ESALS, 9.5 MM MIX, 1 1/2" DEPTH, SRL-H Please note that the specifications are for WMA wearing course. SUPERPAVE ASPHALT MIXTURE DESIGN, WEARING COURSE, PG 64S-22, 0.3 TO < 3 MILLION ESALS, 9.5 MM MIX, 1 1/2" DEPTH, SRL-H (1) Milling of existing pavement on selected roadways to varying depths up to 3" (three inches) prior to paving overlay in accordance with the specifications. The Township will mark the limits and milling depths prior to the start of work. The estimated quantity is based on 7.5' wide curb line milling. Deliver and apply material to resurface roads with a Warm Mix Asphalt WMA SUPERPAVE ASPHALT MIXTURE DESIGN, WEARING COURSE, PG 64S-22, 0.3 TO < 3 MILLION ESALS, 9.5 MM MIX, 1 1/2" DEPTH, SRL-H overlay on existing streets in accordance with the specifications. All questions about the meaning or intent of the Contract Documents shall be submitted to Engineer in writing via online. Questions received less than five days prior to the date for opening of bids will not be answered. Question Deadline 04/18/2025