Site work for a service station / car wash facility in Malden, Massachusetts. Completed plans call for site work for a service station / car wash facility.

DPW Fuel Pumps SCOPE OF WORK The City of Malden is accepting proposals from qualified firms experienced in fuel dispenser replacement. The successful proposer shall provide all equipment, labor and materials necessary for replacement of the fuel dispensers. It is the City's intent to contract with an experienced and licensed contractor to remove two (2) existing fuel dispensers and replace them with new fuel dispensing equipment. One (1) dispenser is unleaded and one (1) is diesel. It is expected that the Contractor provide all materials required for this contract and install, test and certify the two (2) replacement fuel dispensers. The two fuel dispensers are located at the City of Malden Department of Public Works, 356 Commercial St, Malden, MA 02148. The City expects the selected vendor to provide a turn-key solution, which will include all necessary electrical services or upgrades, hoses, swivels, break-away fittings, shut-off nozzles, concrete work and any other materials/services required to complete this project. The City is aware of the following tasks that need to be completed for the replacement of fuel dispensers: o Removal and disposal of three (2) existing fuel dispensers. Current dispensers are Gasboy Model Number 9153AX CXF. The dispensers were installed in 1995. o Provide and install two (2) new single hose fuel dispensers (1 gasoline, 1 diesel) with galvanized frames and stainless steel cabinets. o Site work access hours will be from 7:30 AM - 3:30 PM Monday-Friday. o Contractor will provide all necessary safety precautions during the process and shall preserve the integrity of the fuel, tanks, pumps, wiring, plumbing and other existing equipment. o Contractor will coordinate installation to coincide with the City's operational schedule to minimize fuel service disruptions. It shall be the responsibility of the Contractor to determine quantities of any special materials required and incorporate any such items in his/her cost. The Contractor will be responsible for removing from City property and disposing off site in accordance with all Local,State, Federal, BAAQMD and all EPA regulations, all fuel dispensing equipment which will not be re-utilized. It shall be the responsibility of the bidder to become familiar with the premises specified and the work to be performed according to the specifications. GENERAL SPECIFICATIONS The City of Malden requires that the area surrounding the dispensers be protected from damage that could occur while removing and replacing fuel dispensers. The successful bidder will be responsible for the materials to provide this protection. Special care should be taken to protect the surrounding work area at all times.