Renovation of a municipal facility in Franconia, New Hampshire. Completed plans call for the renovation of a municipal facility.

Part A - Snowbase Compressor Replacement 1. Supply and install a new System Air Compressor ( or similar) with the following specifications: o Same as current size-gallon tank (vertical or horizontal configuration acceptable) o Air-cooled aftercooler o Low oil stop control o Electronic tank drain o Vibration isolation o 3-phase motor o Minimum 25 HP motor o Ability to reach 175 PSI 2. Install and verify full operational status of the new compressor. Part B - Peabody Compressor Replacement 3. Supply and install a new System Air Compressor (or similar) with the following specifications: o 80-gallon vertical tank o Ability to reach 175 PSI o 3-phase motor o Low oil stop control o Electronic tank drain o Air-cooled aftercooler o Vibration isolation appropriate for nearby vibration-sensitive equipment 4. Install and verify full operational status of the new compressor, including proper plumbing and integration with the existing air dryer. 5. Service and verify operational condition of the existing air dryer at the Peabody location. Remove and replace if necessary. Part C - Snowbase Centac Compressor Stage Service/Rehabilitation 6. Take the existing Centac compressor offline and safely isolate it. 7. Remove, clean, and/or replace stage 1 and stage 2 components. 8. Disassemble unit, pressure wash, and soak necessary parts. 9. Reassemble using new gaskets, seals, and bearings. 10. Pressure test and visually inspect the cooler for wear; repair or replace components as needed. 11. Verify proper operational status and correct operating temperature after reassembly. 10/1/2025 Target Implementation of Contract Prior to bidding, it is each Vendor's responsibility to become thoroughly familiar with the sites of the intended service, to determine everything necessary to accomplish the services. Failure of the Vendor to make a site visit does not relieve the Vendor of responsibility to fully understand what is necessary to accomplish a successful and complete annual maintenance agreement. Cannon Mountain Ski Area is requesting the replacement of two existing air compressorsone at the Snowbase facility and one at the Peabody compressor buildingwith new units that meet or exceed current production levels. The new compressors must fit within the existing width and length constraints of each site, with height limited only by ceiling clearance. Installation and full operation are required at least four weeks prior to the snowmaking season. Additionally, bidders must be able to provide regional service and readily available parts to ensure ongoing operational reliability. The State reserves the right to reject any or all bids or any part thereof and add/delete items/locations to the contract. All award(s) shall be, in the form of a State of New Hampshire Contract. Question Deadline 07/11/2025 at 2:00 PM ET Any questions, clarifications, and/or requested changes shall be submitted by an individual authorized to commit their organization to the Terms and Conditions of this bid and shall be received in writing