Renovation of a multi-residential development in Grand Falls-Windsor, Newfoundland. Completed plans call for the renovation of a multi-residential development.

Closing Time: 12:00 PM (NT) Question Acceptance Deadline 2025/07/28 12:00:00 PM NDT .1 Remove existing roof shingles, underlayment's, drip edge, vents, flanges, flashings and dispose of at a proper waste disposal Site. Replace any deteriorated roof sheathing. Unit price to be entered on page TF-8, Schedule "F". .2 Replace any deteriorated fascia boards or metal fascia with new. Unit price to be entered on page TF-8, Appendix "D". .3 Inspect all attic spaces to check for any wet or water damaged insulation. Remove any wet or damaged existing attic insulation and replace with new to match existing type and R-value. Unit price to be entered on page TF-8, Schedule "D". .4 Re-nail existing roof deck, using galvanized nails to penetrate framing by 50mm. Fill in any ridge openings to match existing. .5 Supply and install new roof vents, One in Center of each individual unit, as per specifications and drawing 10-100. .6 Supply and Install new Plumbing vent stack required as per specifications and per drawing 10-101 Section 4. .7 Install new TWO TONE BLACK architectural shingles using high wind application as per manufacturer's instructions using six nails per shingle complete with new drip edge, apply eave protection underlayment parallel to eaves and outlooks and Nova Seal or approved equal as recommended by shingle manufacturer all associated building materials as per specifications and drawing 7-100. .8 Supply new continuous metal eavestrough and downspouts angled away from foundation as per specifications and drawing 7-200-F. At each down spout supply and install new concrete splash block as per specifications. .9 Upgrade existing Attic insulation in all units to R-52 minimum. Ensure proper air flow at eaves as per specifications and drawing 7-200-F. .10 Supply and Install new insulated attic hatch or construct new hatch in each unit (6) as per specifications and drawing 7-401. Official bid documents must be obtained from www.merx.com and bid submissions must be done through the Merx platform.