Renovation of a multi-residential development in Grand Falls-Windsor, Newfoundland. Completed plans call for the renovation of a multi-residential development.

Closing Time: 12:00 PM (NT) ** Please note that there has been 1 addendum issued for this project. ** Question Acceptance Deadline 2025/06/30 12:00:00 PM NDT Shingle Replacement and Attic Insulation Increase 25-35 Brown Ave, GFW To facilitate scaffold set up, existing fences, patios etc. can be removed and reinstalled. The condition of these structures will be documented prior to work beginning. All scaffolds are to be fenced off and secured at all times when not in use by contractor to reduce unauthorized personal entering scaffolding. Contractor is responsible to confirm all dimensions. 1Remove existing roof shingles, underlayment's, drip edge, vents, flanges, flashings. and dispose of at a proper waste disposal Site. Replace any deteriorated roof sheathing. Unit price to be entered on page TF-8, Schedule "F". 2 Replace any deteriorated fascia boards or metal fascia with new. Unit price to be entered on page TF-8, Appendix "D". 3 Remove any wet or damaged existing attic insulation and replace with new to match existing type and R-value. Unit price to be entered on page TF-8, Appendix "D". Re-nail existing roof deck, using galvanized nails to penetrate framing by 50mm. Fill in any ridge openings to match existing. 5 Supply and install new roof vents, One in Center of each individual unit, as per specifications and drawing A-1 Section 5. 6Supply and Install new vent stack required as per specifications and per drawing A-1 Section 4 7 Install new TWO TONE BLACK architectural shingles using high wind application as per manufacturer's instructions using six nails per shingle complete with new drip edge, apply eave protection underlayment parallel to eaves and outlookers and Nova Seal or approved equal as recommended by shingle manufacturer all associated building materials as per specifications and drawing A-1 Section 3. 8 Supply new continuous metal eavestrough and vinyl downspouts angled away from foundation as per specifications and drawing 7-200-F. At each down spout supply and install new concrete splash block as per specifications. 9 Upgrade existing Attic insulation in all units to R-52 minimum. Ensure proper air flow at eaves as per specifications and drawing 7-200-F. 10 Supply and Install new insulated attic hatch or construct new hatch in each unit (6) as per specifications and drawing 7-401. The Total Contract Cost on this Schedule must be carried forward to Request for Quotations Contract (Public Works or Service) Page. Official bid documents must be obtained from www.merx.com and bid submissions must be done through the Merx platform.