Renovation of a mixed-use development in Jacksonville, North Carolina. Completed plans call for the renovation of a 10,500-square-foot educational facility.

Reference Number 0000401837 Bid Intent Not Available The purpose of this bid is to reroof the Jacksonville Commons Middle School cafeteria/kitchen and the gym/locker room roofs. Question Deadline 11/20/2025 at 2:00 PM ET Questions are submitted online No, Refer Inquiries To: Jessica Albright Purchasing Agent Telephone Number: 910-455-2211 EXT 71434 E-Mail Address: Jessica.albright@onslow.k12.nc.us Requisitioned By: Mitch Lofton - Interm Maitainance director Mitch.Lofton@onslow.k12.nc.us 910-455-2211 EXT 71413 Onslow County Schools reserves the right to reject any and all responses, to waive any informality in the process and, unless otherwise specified by the offeror, to accept any item in the quote. If either a unit price or extended price is obviously in error and the other is obviously correct, the incorrect price will be disregarded. All measurements are the responsibility of the contractor Roofing scope of work i|H "**_"&" -A. Removal of existing EPDM single ply membrane, existing metal trim down to existing insulation and fiberboard (if any) and the recovering of roof with new _" gypsum core boards with fiberglass facer mat (Dens Deck Prime Roof boards by Georgia Pacific, or equivalent and a new 60 mil, reinforced, smooth white, fully adhered TPO membrane roofing system with 20-year NDL manufacturer's warranty. Contractor is responsible for the legal disposal of all debris. The existing insulation and roof deck shall remain in place. Roof areas are sloped, any areas found to pond water or where 1/8" per foot minimum roof slope does not exist shall be provided by crickets or tapered insulation for positive drainage. All areas shall receive _" thickness gypsum core board over existing insulation. Remove and remount any HVAC Equipment as needed to complete new roofing installation. When roof is completed, the Contractor shall reinstall, reconnect, reposition any roof mounted equipment, fans, HVAC units, electrical wires, lights, ground wires, devices and other items removed during the roofing installation. Perimeter edge (coping) and facia shall be formed of preprinted aluminum, 10-foot minimum sections, extending on roof not less than 4". Where there are existing roof drains they are to remain, provide new bolts in the clamping, compression rings.Where the clamping, compression rings are damaged or broken, provide new cast iron clamping, compression rings with new cast iron domes. Plastic domes and retrofit-type drains are unacceptable.