Remodeling of an educational facility in Stockton, California. Completed plans call for the remodel of a 15,000-square-foot, one-story above grade educational facility.

Remove and properly dispose of all 12 x 12 tile flooring on the 1st floor of George Lincoln Mosher Elementary School. Verify total area before starting; estimated at approximately 15,000 square feet of flooring and baseboards. Ensure minimal damage to underlying concrete during tile removal. Provide dumpster and dispose of all tile, adhesive, and debris in accordance with local waste regulations. Clean concrete surface to remove adhesive and contaminants. Grind surface imperfections to achieve a smooth, level finish. Use a dust collection system to minimize airborne particulates. Perform patching or repairs as needed to ensure a uniform surface. Power scrub and/or wet mop entire surface to remove all dust. Apply commercial-grade densifier following manufacturer’s recommendations. Apply district-approved color/stain, ensuring uniform coverage without blotches or streaks. Polish concrete to a semi-gloss finish using a multi-step polishing system. Apply compatible sealant or guard to protect the surface and enhance durability. Finished floor must be smooth, uniform, slip-resistant, and free of defects or haze. Install new black rubber baseboards. Perform final cleaning of walls, ceilings, windows, and doors. Include asbestos removal/abatement as required. All bids shall be on the form provided by the District. Each bid must conform and be responsive to all pertinent Contract Documents, including the Instructions to Bidders. To bid on this Project, the Bidder is required to possess one or more of the following State of California contractors license: A, B, and/or C-15. The Bidder's license(s) must remain active and in good standing throughout the term of the Contract. The Bidder is required to be registered as a public works contractor with the Department of Industrial Relations. Only prequalified bidders will be eligible to submit a bid for this Project. Contractors can apply for pre-qualification via the district PQBids website. A bid bond by an admitted surety insurer on the form provided by the District, a cashier's check or a certified check, in the amount of ten percent (10%) of the total bid price, shall accompany the Bid Form and Proposal. The successful Bidder shall be required to furnish a 100% Performance Bond and a 100% Payment Bond if awarded the Contract. The Contractor and all Subcontractors must pay all workers not less than the general prevailing rate of per diem wages as determined by the Director of the Department of Industrial Relations, State of California. Attendance at a mandatory pre-bid conference and site visit is required. Failure to attend or tardiness will render bid ineligible. The successful Bidder must comply with all requirements of the California Labor Code concerning public works projects. The District shall award the Contract to the lowest responsive responsible bidder based on the base bid amount only. The Board reserves the right to reject any and all bids and/or waive any irregularity in any bid received. No bidder may withdraw its bid for ninety (90) days after the date of the bid opening. Pre-qualification requirements: Possession of a State of California contractors license (A, B, and/or C-15) in active and good standing; registration as a public works contractor with the Department of Industrial Relations; successful completion of district pre-qualification via PQBids. The Project consists of: o Remove and properly dispose of all 12" x 12" tile flooring on the 1st floor of George Lincoln Mosher Elementary School. o Verify total area before starting; estimated at approximately 15,000 square feet of flooring and baseboards. o Ensure minimal damage to underlying concrete during tile removal. o Provide dumpster and dispose of all tile, adhesive, and debris in accordance with local waste regulations. o Clean concrete surface to remove adhesive and contaminants. o Grind surface imperfections to achieve a smooth, level finish. o Use a dust collection system to minimize airborne particulates. o Perform patching or repairs as needed to ensure a uniform surface. o Power scrub and/or wet mop entire surface to remove all dust. o Apply commercial-grade densifier following manufacturer's recommendations. o Apply district-approved color/stain, ensuring uniform coverage without blotches or streaks. o Polish concrete to a semi-gloss finish using a multi-step polishing system. o Apply compatible sealant or guard to protect the surface and enhance durability. o Finished floor must be smooth, uniform, slip-resistant, and free of defects or haze. o Install new black rubber baseboards throughout. o Perform final cleaning of walls, ceilings, windows, and doors. o Include asbestos removal/abatement as required All questions about the meaning or intent of the Contract Documents are to be directed via email to the District to Lance Brown, lbrown@lodiusd.net. Question Deadline 11/18/2025 at 1:00 PM PT