Renovation of an industrial development in Durham, Connecticut. Completed plans call for the renovation of a one-story above grade industrial development.

The Town of Durham is seeking competitive bids for the purchase and installation of an HVAC system at the Town of Durham Public Works Garage, 20 Cream Pot Rd., Durham, CT 06422. All bids must be in a sealed envelope and clearly marked with 'HAVC System-Public Works Garage.' Sealed bids will be accepted in the First Selectman's Office, 30 Town House Road, Durham, CT 06422, until 2:00 p.m., at which time they will be publicly opened and read. Faxed or emailed bids will not be accepted. Bidders must comply with all the provisions listed in the proposal. All requests for additional information and/or questions should be directed, in writing, to Charlie Bedo at cbedo@townofdurhamct.org or no later than December 26, 2025 at 9:00 a.m. Project Objectives The Town of Durham is seeking bids from qualified and responsible entities for a complete and codecompliant heating and cooling system for the 40' x 60' Public Works facility. The system shall include all equipment, materials, controls, and labor necessary for full installation and operation. Scope of Work The specifications listed below set forth the necessary requirements to install an HVAC system at the Public Works Garage. 1. System Requirements o Furnish and install adequate heating and cooling equipment sized appropriately for the facility. o All equipment must comply with current local, state, and federal codes and standards. o Electrical power for all new equipment shall be provided as part of this contract, including wiring, disconnects, and any required upgrades. 2. Existing Conditions o The building is currently heated by a propane Trinity TS80 boiler supplying the radiant floor only and will remail. o The contractor shall review existing conditions and determine all modifications needed to integrate new systems. 3. Contractor Responsibilities o Perform all required alterations to the existing building systems, including mechanical, electrical, and structural modifications, as needed for installation. o Provide all permits, inspections, and documentation required for code compliance. o Verify proper operation of the complete system upon completion. o All work must be completed by May 1, 2026.