Renovation and addition to an educational facility in Erie, Pennsylvania. Completed plans call for the addition of a educational facility; and educational facility.

Additions and alterations are to be performed for Grover Cleveland Elementary School. Separate contracts will be awarded for General Construction, HVAC Construction, Plumbing Construction, Electrical Construction, and Asbestos Removal. Bidders for contracts 1 through 4 must follow the contract documents prepared by HHSDR Architects/Engineers. Bids for asbestos removal shall comply with contract documents provided by Intertek-PSI. All bids must include a Bid Security Bond or Certified Check for five percent of the bid amount. Bidders must comply with the Responsible Contracting with the District Policy. Bids must be submitted as specified, properly marked with the project name, and delivered either in person, by mail, by contract carrier, or electronically to the specified email address. Late bids will be rejected. A. The work to be performed under these Specifications shall include providing all labor, materials, and equipment necessary to furnish and install, complete, properly, and fully all plumbing work as shown on the Drawings or herein specified. It is the intent of these Specifications that a complete operating system be installed; this Contractor shall carefully examine the site, drawings, and Specifications, and shall include all items necessary to accomplish this purpose. The work, in general, shall include, but shall not be limited to the following: 1. Provide storm drainage systems as indicated. Extend storm sewers 5'-0" outside of exterior walls, for extension under the Site Contract. Final connections by the Plumbing Contractor. Provide roof drains. 2. Provide interior sanitary and vent drainage system as indicated, including floor drains, cleanouts, traps, and vents. 3. Provide interior domestic hot and cold water distribution systems as indicated. Provide valves and backflow preventers. 4. Provide domestic hot water heating equipment. 5. Provide plumbing fixtures and equipment shown. 6. Provide elevator sump pumps with alarm systems. 7. Provide plumbing services and final connections for equipment furnished under various Contracts or by the Owner as indicated. 8. Provide insulation for piping and equipment as specified. 9. Testing, adjusting and balancing all plumbing piping and equipment. 10. Furnish combination starter/disconnects, magnetic starters, manual starters, and fused disconnect switches, to the Electrical Contractor for installation on all plumbing equipment. Coordinate all electrical requirements with the Electrical Contractor before ordering such equipment. 11. Type "RK" fuses for the starter/disconnect switches shall be furnished and installed under the Plumbing Contract as specified. The Plumbing Contractor shall properly size and select overloads and disconnect switch fuses in accordance with the National Electrical Code requirements. The Plumbing Contractor shall furnish to the Electrical Contractor the equipment manufacturer's circuit protection data. 12. All control and interlock wiring shall be by the Plumbing Contractor. 13. Provide all necessary demolition of existing piping, fixtures, and equipment as indicated. Question Deadline 01/19/2026 Bidders shall not rely on any verbal clarification of the drawings and specifications. Any questions or clarifications shall be referred to Engineer at least seven (7) working days prior to bidding to allow for issuance of an addendum.