Renovation of a municipal facility in Las Vegas, Nevada. Completed plans call for the renovation of a municipal facility.

The work consists of all labor, materials, utilities, permits, devices, systems and equipment necessary to demo one (1) existing 250mbh Lochinvar atmospheric boiler and (1) existing boiler circulation inline pump, air separator, expansion tank, piping, supports, devices and other associated systems per project drawings within this set of plans and manuals, and replace with (2) 500mbh non condensing (near condensing) boilers, working in unison and providing redundancy, and (2) boiler circulation pump, piping, supports, devices and other associated systems as required for successful installation and operation of the systems. Question Deadline 03/17/2026 at 5:30 PM PT *prebid info : If your firm is unfamiliar with the County Bid Submittal procedures and would like to obtain training on the submittal process for this Bid, please contact Geraldine Cruz, Purchasing Analyst, at (702) 455-6277 no later than MONDAY, MARCH 9, 2026, and a training session will be provided immediately following the pre-bid conference ESTIMATED COST: $426,774.20 - $449,236.00. *The value for this project is based on a financial range. The value is listed as the highest possible cost from the range provided by a stakeholder or official project document. 1. THE "PROJECT" OF WHICH THE "WORK" OF THE CONTRACT IS PART TITLED: PINTO CAMPUS IT BOILER REPLACEMENT LOCATED AT 1670 PINTO LANE LAS VEGAS NV 89106. THE "WORK" IS DESCRIBED IN THE PROJECT DRAWINGS AND SPECIFICATIONS DIVISION 1 THROUGH DIVISION 48 OF THE PROJECT MANUAL. 2. "WORK" OF THIS PROJECT INCLUDES BUT IT IS NOT LIMITED TO DIVISIONS 0, 1, 2, 3, 4, 22, 23 & 26. 3. THE WORK CONSISTS OF ALL LABOR, MATERIALS, UTILITIES, PERMITS, DEVICES, SYSTEMS AND EQUIPMENT NECESSARY TO DEMO ONE (1) EXISTING 250MBH LOCHINVAR ATMOSPHERIC BOILER AND (1) EXISTING BOILER CIRCULATION INLINE PUMP, AIR SEPARATOR, EXPANSION TANK, PIPING, SUPPORTS, DEVICES AND OTHER ASSOCIATED SYSTEMS PER PROJECT DRAWINGS WITHIN THIS SET OF PLANS AND MANUALS, AND REPLACE WITH (2) 500MBH NON CONDENSING (NEAR CONDENSING) BOILERS, WORKING IN UNISON AND PROVIDING REDUNDANCY, AND (2) BOILER CIRCULATION PUMP, PIPING, SUPPORTS, DEVICES AND OTHER ASSOCIATED SYSTEMS AS REQUIRED FOR SUCCESSFUL INSTALLATION AND OPERATION OF THE SYSTEMS. 4. "WORK" AT BOILER ROOM AND ADJOINING AIR HANDLER ROOM, BOTH ARE REFERRED AS "MECHANICAL ROOMS" ALSO CONSIST OF PIPING/FITTINGS, HYDRONIC VALVES AND APPURTENANCES, CONTROL VALVES, PIPING SUPPORTS, EQUIPMENT PADS, NATURAL GAS PIPING, FLOOR DRAIN AND FLOOR SINK AND ASSOCIATED PIPING, FLUE AND COMBUSTION PIPING AND ELECTRICAL POWER AS NECESSARY FOR REMOVAL OF EXISTING AND CONNECTION TO THE NEW EQUIPMENT AND SYSTEMS. 5. NATURAL GAS SERVICE WORK INCLUDES REMOVAL OF EXISTING METER, REGULATOR AND PIPING AND INSTALLATION OF (1) NATURAL-GAS METER, REGULATOR AND ASSOCIATED PIPING AND COORDINATION WITH SOUTHWEST GAS COMPANY. 6. ROOFING WORK INCLUDES PATCHING EXISTING FLUE PIPE ROOF OPENING AND NEW ROOFING FOR (2) BOILER FLUE VENT PIPES. 7. STRUCTURAL CONCRETE WORK INCLUDES EXTENDING OF EXISTING 4" CONCRETE PAD INSIDE THE MECHANICAL ROOM TO ACCOMMODATE FOR INSTALLATION OF NEW BOILERS. PROVIDING WALL OPENINGS FOR COMBUSTION AIR LOUVERS. 8. "WORK" INCLUDES TESTING, ADJUSTING AND BALANCING OF THE ENTIRE HEATING HOT WATER HYDRONIC SYSTEM. 9. SYSTEM COMMISSIONING TO BE PROVIDED PER REQUIREMENTS OF CONTRACT DOCUMENTS. 10."WORK" INCLUDES JOHNSON CONTROLS "JCI" TO REMOVE EXISTING CONTROLS AND CONNECT NEW SYSTEM AND INTEGRATE TO EXISTING CONTROL SYSTEMS. CONTRACTOR TO CONTRACT JCI FOR NEW CONTROLS AND SEQUENCING SETUP, AND INTEGRATION OF THE NEW AND EXISTING BACNET CONTROL SYSTEMS. 11.WORK SEQUENCE: "WORK" TO BE PERFORMED DURING THE WARM MONTHS OF A YEAR WHEN SPACE HEATING WILL NOT BE REQUIRED. 12.REFER TO DIVISION 01 SPECIFICATION SECTION 01 11 00 SUMMARY OF WORK FOR ADDITIONAL REQUIREMENTS. pn-18-43135-49