Site work and paving for a road / highway in Conroe, Texas. Completed plans call for site work for a road / highway.

The scope of work is the construction of Phase 1 TxDOT Improvements for Pinara Pines FM 1484. Bidders must submit sealed electronic bids via www.CivcastUSA.com, including a bid bond or certified/cashier's check equal to at least 5% of the total bid as a guarantee. The successful bidder must provide executed bonds and required insurance certificates within seven days after receiving the contract documents. All bids and securities must be submitted through the designated website. Bidders must register on the website to review or download the project specifications, plans, soils report, and environmental reports. Instructions to bidders include submitting all documents electronically through www.CivcastUSA.com, following the Owner's Order Adopting Section 49.2731 Electronic Bidding Rules, and acknowledging that contracts may be executed with electronic signatures. The Owner reserves the right to reject any or all bids and to waive defects and irregularities except for bid submission time. The bid must comply with all relevant statutory and regulatory requirements and may be terminated if a contractor knowingly or intentionally fails to comply with applicable law. Question Deadline 05/01/2026 at 12:00 PM CT submit a written request online to the system for such information to Engineer not less than seven (7) calendar days before the Bid opening. STORM SEWER STAKING o All MH's and inlets will be staked o MH: Center of MH with an offset and line only stake o MH Offset: Will have cuts to all flowlines in the MH o Inlets: Staked at back of curb when possible or with offsets to back of curb, depending on site conditions. Each inlet will have a stake at centerline of inlet at back of curb and an offset up and down the curb line (or offsets of such). Cuts to flow lines will be shown o Stakes will have blue flagging PAVING STAKING o Paving will be staked on an offset line parallel to the back of curb, the offset stake will have a distance to back of curb and a cut/fill to top of curb. Stakes will be at even 50ft stations, horizontal PC's & PT's and vertical VPI's. Vertical curves will be staked at 10ft intervals. o All streets will be staked on both sides. o Curb returns will be staked with offset and cut/fill to top of curb. o Radius points (at curb returns) will be staked, marked with the back of curb radius distance. o Stakes will have white flagging. GRADE STAKING o Swale will be staked on 15ft offset from centerline of swale at 50ft intervals o Provide a line with crows' foot and cut/fill to design elevation. o All grade stakes will be staked with a wooden lath and orange flagging.