Renovation of a mixed-use development in Templeton, Massachusetts. Completed plans call for the renovation of a educational facility.

The project includes removal and replacement of roughly 35,000sf of EPDM and 55,000sf of metal roofing. Also includes removal and reinstallation of mechanical units, replacement of roof drains, structural reinforcement, ACT ceiling replacement, and conduit for solar readiness. Sub Bid Category Masonry, Roofing & Flashing, Acoustical Tile, Plumbing, HVAC, & Electrical. Contractor Qualification DCAMM Certificate Required for DCAMM contracts over $150,000, Highway Division contracts over $50,000. Work Included: Provide labor, materials and equipment necessary to complete the work of this Section, including but not limited to the following: 1. 2. 3. 4. 5. 6. 7. Concrete masonry units. Face brick. Embedded flashing. Mortar and grout. Reinforcing steel, masonry joint reinforcement, ties and anchors. Hoisting Equipment: The Masonry subcontractor shall furnish, install, and maintain in safe and adequate condition, all mechanical hoisting equipment, operating personnel, and rigging that is necessary for the proper execution of the Work of this Section. The requirements of Section 015000 - TEMPORARY FACILITIES, in relation to hoisting and rigging being the responsibility of the General Contractor, do not apply to the work of this Section. Staging, Planking and Scaffolding: The Masonry subcontractor shall furnish, install and maintain in safe and adequate condition, all staging, planking and scaffolding up to eight feet in height that is necessary for the proper execution of the Work in this Section. The General Contractor shall furnish, install, and maintain in safe and adequate condition all staging, planking, and scaffolding above eight feet in height. Question Deadline 05/26/2026 at 4:00 PM ET submitted online