Site work and paving for a sidewalk / parking lot in San Marcos, Texas. Completed plans call for site work for a sidewalk / parking lot; and for paving for a sidewalk / parking lot.

Reference Number 0000424257 Source ID PU.AG.USA.1605725.C21514801 Piggyback Contract No Hays County issues this Invitation for Bid (IFB) to solicit bids to Remove existing 6" and replace with 4" of Type B Hot Mix and 2" Type D Hot Mix Overlay on Campo del Sol Parkway, located in the Sunfield Subdivision. Question Deadline 05/28/2026 at 5:00 PM CT Questions are submitted online No Bonding Requirements Bid(5.0%), Performance(100.0%), Payment(100.0%) Specification Item 351, SS 3076, SS 3077, and SS 3084 of the Texas Department of Transportation's Standard Specifications for Construction and Maintenance of Highways, Streets and Bridgesshall govern this project. A TRAIL tack coat placed priorto paving with Type D mix is specified. Contractor shall provide QA/QC with the required bulk samples and cores per specification for each day's work for conformance with density and specification requirements. Milling/ B mix Paving: o In locations determined by the Hays County Representative pavement will be milled to 6" of depth from existing paving. The Contractor will be responsible for repairs/damage to utilities while removing around manhole castings to a depth of 6". The Contractor will provide the trucking and dumpsite for haul off materials. After milling the location will be free of loose material and a tack coat applied to the gutter face and manholes prior to paving. The Contractor will be responsible to provide safe access for resident's driveways prior to B mix installation. B mix shall not be placed until underlying base is approved by Hays County. Proof rolling of the prepared base may be required, rutting or pumping will require rework. 4" of TXDOT Special Specification 3076 Type B shall be placed and compacted per specifications. Overlay Paving Operations: o A TRAIL tack coat to be applied along with curb/pavement edges and manhole rings followed by a 2" overlay of TXDOT Special Specification 3077 D mix. Finished pavement will match existing curb, manhole and pavement unless specified by the County Representative. Paving will be conducted per specifications. Post-Paving Cleanup: o All post-paving clean-up will be the responsibility of the Contractor. Traffic Control/Safety Operations: o Safety warning signage, flagger operations, pilot car, and traffic controlshall be the responsibility of the Contractor and shall meet TxDOT standards. Scheduling: o All paving operations shall be scheduled through the Hays County Transportation Department. Paving Worksites: Bid according to bid sheet instructions: 1. Campo del Sol Parkway a. Mill 6" depth b. Replace 4" (B mix) 5,410 SYD 2. Campo del Sol Parkway 2" Overlay a. 2" D mix overlay 5,410 SYD b. Trail tack to be applied prior to overlay 3. Contractor is responsible for removing, by milling to a depth of 6". a. Milling Operations: Contractor is responsible for milling, rolling, and otherwise preparing the underlying base to accept the new hot mix surface. Edges will be tacked. b. Contractor will be responsible for utility locates and any damages/repairs to utilities. c. The Contractor will provide trucking and haul off site for materials. d. Reference Attachment B: Campo del Sol Parkway Map (locations are estimated/actual locations will be determined by a Hays County Representative) e. B mix shall not be placed until underlying prepared base is approved by Hays County. Proof rolling of the prepared base may be required, rutting or pumping will require rework.