Renovation of a water / sewer project in Florida City, Florida. Completed plans call for the renovation of a water / sewer project.

This project is for the refurbishment of the 5810 PH Motor and Pump at the FKAA J.R. Dean Florida City Water Treatment Plant. Questions regarding this bid should be directed in writing via email to David Jackson, Purchasing Manager at djackson@fkaa.com. EQUIPMENT- 3 PHASE VERTICAL MOTOR, HP: 800, RPM'S: 1770, VOLTS: 4160 MAKE- FRAME: 5810 PH, EMERSON-US MOTORS MOTOR SCOPE QUANTITY OF 1 : PICKUP MOTOR FROM LOCATION: J ROBERT DEAN WTP, 35400 SW 192 AVE HOMESTEAD, FL 33034 - PERFORM A VISUAL INSPECTION OF MOTOR COMPONENTS FOR THE PRESENCE OF CONTAMINATION BY DUST, DIRT, MOISTURE, OIL, AND OTHER FOREIGN MATTER. DISASSEMBLE MOTOR AND ATTEMPT TO DETERMINE THE ORIGIN OF FAILURE, SUCH AS LEAKING SEALS, LOOSE MECHANICAL COMPONENTS OR ANY UNUSUAL CONDITIONS PRIOR TO THE START OF CLEANING. NOTE ALL ABNORMAL CONDITIONS ON THE STATOR, ROTOR, AND WINDINGS. CAREFULLY EXAMINE THE INTERIOR OF THE MOTOR FOR LOOSE OBJECTS SUCH AS, NUTS AND BOLTS. REMOVE ALL SUCH ITEMS. INSPECT ALL ELECTRICAL CONNECTIONS FOR TIGHTNESS. CHECK ALL WEDGES, BANDS, AND SOLDERED CONNECTIONS AND CORRECT ANY MINOR DEFICIENCIES. CHECK FOR EVIDENCE OF OVERHEATING, BOTH GENERAL AND LOCALIZED. IDENTIFY ANY MECHANICAL DEFICIENCIES. RECORD ALL FINDINGS, INCLUDING THE TYPES OF CONTAMINANTS (OIL, WATER, CARBON, DIRT, ETC.) FOUND. - INSPECT ANY MOTOR ACCESSORIES, SUCH AS TEMPERATURE SENSOR, SPACE HEATER, CAPACITOR, TACHOMETER, ELECTROMAGNETIC BRAKE, OR SPACE HEATER, AND THE ASSOCIATED INTERNAL WIRING. TEST ACCESSORY OPERATION AND SUBMIT A FINDING REPORT WITH RECOMMENDATIONS FOR REPAIR OR RENEWAL. - CLEAN & REPLACE ALL BEARINGS, BEARING JOURNALS, HOUSING, SEAL SURFACE, CONTROL CABLE, ETC..., AS APPLICABLE, DOCUMENT FINDING. - PERFORM CORE LOSS TEST OF STATOR AND ROTOR LAMINATIONS IN ORDER TO DETERMINE IF CORE LAMINATIONS MAINTAIN THE ORIGINAL DESIGN EFFICIENCY. - PERFORM A COMPLETE ELECTRICAL EVALUATION OF BOTH STATOR AND ROTOR (PI, IR TO GROUND, PHASE COMPARISON TEST, PHASE RESISTANCE, WINDING RTD'S, HEATERS). - SAND BLASTING ALL PARTS AND MISCELLANEOUS COMPONENT AS DEEMED NECESSARY. - STEAM CLEAN STATOR AND BAKE DRY IN A TEMPERATURE CONTROL OVEN. DOUBLE DIP AND BAKE WINDING - VACUUM PRESSURE IMPREGNATE (VPI) WINDINGS IN A 100% EPOXY SOLVENT LESS RESIN. - FURNISH AND INSTALL NEW ANTIFRICTION BEARING. - DYNAMIC BALANCE ROTOR IN ACCORDANCE WITH ISO 1940 2.5 STANDARDS. - ASSEMBLE MOTOR, CONDUCT ELECTRICAL TEST WHEN COMPLETED. - CLEAN AND PAINT EXTERIOR. - PROVIDE AS LEFT FINAL REPORT - DELIVERY MOTOR AT CUSTOMER LOCATION. PUMP SCOPE QUANTITY OF 1 EQUIPMENT: VERTICAL TURBINE, RPM: 1780, TYPE: SJT, 7 STAGES MAKE: SULZER PICKUP PUMP FROM LOCATION: J ROBERT DEAN WTP, 35400 SW 192 AVE HOMESTEAD, FL 33034