Renovation of an educational facility in Loxahatchee Groves, Florida. Completed plans call for the renovation of a educational facility.

Certified Roofing Contractors, licensed by the State of Florida and prequalified by the School Board, are invited to submit Bids for Roofing Services at Loxahatchee Groves Elementary School, located at 16020 Okeechobee Blvd., Loxahatchee, FL 33470. The ITB document may be obtained from BidNet Direct. The School Board reserves the right to waive minor technicalities in any Bid. Question Acceptance Deadline 07/06/2026 05:00 PM EDT all questions regarding this solicitation must be submitted via online Scope of work is to install a new roof on buildings 1-8, including but not limited to: o Delegated engineering, including signed and sealed shop drawings and calculations for all items exposed to wind. o Contractor's delegated engineer shall provide engineering solutions for concealed conditions, roof-mounted equipment o supports and conditions that deviate from or are prohibitive to performing the work as shown in the drawings. o remove shingles, underlayments, flashings & metals down to the existing plywood. inspect existing plywood and o polyiso insulation. replace any plywood and/or insulation boards where moisture or deteriorated wood is found. o install new roof system. o remove gutters, downpipes & downspouts, flashings, drip edges, expansion joints, custom metal shapes, and roof o metals and replace with new. o repair and paint. o joint sealants. o prefinished metal panel system repair and replacement as needed. o install crickets at all roof curbs. existing curbs shall remain. o remove kitchen supply fan supports and pitch pans and replace with new. install curb adapter at intake plenum. o Delegated engineering, including signed and sealed shop drawings and calculations for all items exposed to wind. Contractor's delegated engineer shall submit signed and sealed shop drawings detailing supports and structural attachment. o re-flash all roof-mounted equipment, including but not limited to: curbs, VTRs, and supports, whether shown on the plans or not. o install vent extensions with vandal-resistant caps. Remove gooseneck vents and replace with new. o disconnect, remove, store, reinstall, and reconnect roof equipment as required to perform the work. rework o electrical, chwr piping, and condensate drain line piping as required to accommodate new roof surface height. o all downpipes & downspouts shall be camera inspected and jetted to the nearest catch basin. o vacuum debris from catch basins after jetting lines. o Pruning of existing trees