Site work and renovation of a municipal facility in Rome, New York. Completed plans call for the renovation of a municipal facility; and for site work for a municipal facility.

Replacement of concrete slab at IRA 5 facility. SCOPE OF WORK includes, but is not necessarily limited to the following: 1. Slab Remove existing pavers and earth. 2. 3. 4. 5. Cut away and remove any shrubs, roots or stone that will interfere with this work Compact sub grade Place a minimum of 4" inches of compacted crushed stone NYS DOT 304-1, type 4 Install reinforcing 6"x6" W1.4xW1.4 WWM wire mesh at a depth o f 2", anchor securely, using 16 gauge or heavier, black annealed wire. 6. gradation in base of framework. Apply in (2), 2" layers, compacting each layer. Refer 7. 8. 9. to print. Pin into existing concrete using #4 bar at 12" on center at least 8-12 inches of depth. Core drill to required depth, use a two-component required epoxy to set the #4 rebar and concrete bonding agent to additionally adhere the two slabs. No concrete to be poured when temperature is expected to be below 40 degrees Fahrenheit. Pour 5" of concrete. Concrete is to be air retained concrete with a minimum compressive strength of 4000 psi. aggregates No-1 crushed stone. Refer to print. 10. Consolidate concrete by spading, raking, forking, or using vibrator eliminating all air pockets, stones pockets and honey combing work. Float concrete surfaces so as to produce a uniform finish. 11. Provide a broom finish to all surfaces. 12. Finish edges of walks and expansion joints with a _" radius edging tool. Provide control joints every 5' 13. Apply anti curing and anti-spalling compound after finishing and when the surfaces if firm enough to walk on. Apply 2 coats at a combined coverage of 175 to 250 square feet per gallon. Sonneborn penetrating sealer or same quality product. 14. Apply topsoil, grade and reseed any lawn damage when finished. 15. See site map for areas of replacement. 16. Comply with American concrete institute, ACU 301-72 work in this section. 17. Contractor shall follow all manufacturers specifications for all products used. 18. Work being performed will meet all applicable building codes.