Outdoor lighting and renovation of a playground / park / athletic field in Wilton Manors, Florida. Completed plans call for the renovation of a playground / park / athletic field; and for outdoor lighting for a playground / park / athletic field.

Electrical service remodel including replacement of corroded electrical service riser, bringing existing system to NEC standards, and installation of receptacle power and lighting posts, with an optional alternate for LED pagoda-style post-top fixtures. Pre-Bid Meeting 09/09/2026 at 3:00 PM ET Question Deadline 09/15/2026 7 .00 pm To facilitate receipt of questions, they may be sent via email to amontalvo@wiltonmanors.com, Ariel Montalvo, Purchasing Coordinator. PLEASE NOTE: No portion of your bid response can be sent via facsimile ( FAX) or electronic email.For information concerning procedures for responding to this ITB, contact Elizabeth Beckford, City Clerk at cityclerk@wiltonmanors.com or (954) 390-2123 Response to Questions September 22, 2026 The successful bidder shall furnish all labor, materials, equipment, and supervision necessary to complete the following tasks: Base Bid A: 7.01 DEMOLITION AND REMOVAL o Service Equipment: Demolish and remove the existing corroded meter combo, panels, timeclocks, photocells, contactors, and miscellaneous electrical components currently mounted on the service pole. o Disposal : Properly dispose of all removed materials in compliance with local environmental regulations. 7.02 ELECTRICAL SERVICE RISER & MAIN DISTRIBUTION o Mounting Rack: Install a new Unistrut rack on the existing concrete pole to support new equipment mounting. o Meter Can : Install one (1) new 1-Phase (1PH ), 200A meter can. o Load Center: Install one (1 ) new 1PH , 200A, 250V NEMA-3R load center with a 200A main breaker. Minimum 40-circuit capability required.o Generator Interlock: Re-install the existing 100A, 250V power inlet receptacle for backup generator use, including a mechanical interlock kit with a 100A breaker to safely manage backup power. o Grounding: Install two (2) 8-foot copper (CU ) ground rods and a complete grounding system. o Service Receptacle: Install one (1) 20A GFCI service receptacle at the main panel location. o FPL Coordination: Coordinate with Florida Power & Light ( FPL) for reuse of the existing FPL drop, 1.5" RMC conduit, and 3/0 THHN wires from the weather head to the new meter can .