Site work and renovation of an educational facility in Montgomery, Alabama. Completed plans call for the renovation of a educational facility.

Installation of new electrical outlets in eight locations (Rooms 125, 128, 140, Seminar rooms 1-4, and Lecture Hall RM 165) in building G832 to support instructional activities. . Project Overview Statement of Work (SOW) Ira C. Eaker Center for Leadership BLDG 832 Install Nineteen (19) Electrical Outlets at Bldg. G832 Prepared By: Eaker Center Facility Managers This project involves the installation of new electrical outlets in eight (8) locations. Rooms 125, 128, 140, Seminar rooms 1-4 and the Lecture Hall RM 165 in building G832 . The purpose of these outlets is to support instructional activities by providing reliable power sources for classroom electronics, including laptops, projectors, document cameras, and other teaching equipment. 2. Objectives Provide sufficient electrical access to support modern classroom technology. Ensure outlets are installed in locations that maximize usability for instructors and students. Meet all electrical code requirements and institutional safety standards. Minimize disruption to ongoing academic activities. 3. Scope of Work 3.1 Site Assessment Conduct a walkthrough of the eight (8) locations the outlets are required. RM 128 - install one ( 1) electrical outlet on the wall for the tv. RM 125 - install one ( 1) electrical outlet on the wall for the tv. RM 140 - install three (3) electrical outlets on the wall for tv's. Seminar room #1 - install one (1 ) floor mounted electrical outlet. Seminar room #2 - install one (1) floor mounted electrical outlet. Seminar room #3 - install one (1) floor mounted electrical outlet. Seminar room #4 - install one (1) floor mounted electrical outlet. Lecture Hall - install ten ( 10) floor mounted electrical outlets. Verify available electrical capacity and panel load. Electrical Installation o Install new 120V duplex electrical outlets at designated locations in each room. Provide necessary conduit, wiring, junction boxes, and mounting hardware. Tie new outlets into existing electrical circuits or install new circuits if required.