Site work and renovation of a municipal facility in Okeechobee, Florida. Completed plans call for the renovation of a municipal facility.

Removal of existing shingles and installation of new thirty-year Timberline Architectural roof shingles, aluminum drip edge, leak barriers, deck protection, ridge vents, ridge caps, flashing, and pipe collars at the Brighton Reservation. The Scope of Work (SOW) contained in the Attachments as Attachment A Scope of Work describes the services expected for CONTRACTOR to provide the TRIBE. BIDDER must ensure all such services contained in Attachment A are provided for in every particular and shall meet or exceed the level of quality, availability, features, functionality, frequency, accuracy, and performance. The silence of specifications or requirements as to any detail contained in this document or any of the Attachments, or the apparent omission from any specifications or requirements , or a detailed description concerning any point, shall be regarded as meaning that only the best commercial practices shall prevail and that only material and workmanship of the finest quality are to be used. All interpretations of the SOW shall be made on the basis of this statement. ROOF REPLACEMENT: Remove existing shingles and responsibly dispose. Inspect all sheathing for possible damage. If damage is found, CONTRACTOR must stop work until contact is made with the TRIBE's Project Manager to receive direction. Pictures of damaged area must be taken. Install aluminum drip edge along all edges, eaves, and rakes per residential building code. Install leak barrier(s) at all eaves, valleys, and around penetrations. Install deck protection over remaining wood decking. Install thirty (30) year Timberline Architectural roof shingles (Color to be determined) using one and a quarter inch ( 1 1/4 ") hot dipped coil nails penetrating at nail zone. Replace all flashing that can be accessed without damaging siding materials, including counter, step, and apron flashing with new color coated aluminum. Step flashing must be four inches (4"). Any flashing fastened to masonry must be cut into masonry. Seal all exposed nail heads and transitions. Install and seal pipe collars. Install color matching ridge vent. Install ridge cap shingles over all hips and ridges using two-inch (2") nails Bonds: Bid Bond required (unspecified amount).