Renovation of a municipal facility in Duchesne, Utah. Completed plans call for the renovation of a municipal facility.

Furnish all labor, materials, equipment, tools, transportation, and incidentals necessary to remove the existing 5-ton air-cooled refrigerant condenser unit and associated indoor coil and provide and install a new 2.5-ton air-cooled condenser unit and compatible indoor coil. Work includes disconnecting, recovering, and properly disposing of refrigerant in accordance with federal and state environmental regulations; removing the existing condenser, indoor coil, piping, electrical connections, mounting hardware, and associated components; installing the new condenser and coil with all required refrigerant piping, line sets, insulation, fittings, mounting pads, vibration isolation, and supports; completing necessary electrical modifications and reconnections; pressure-testing, evacuating, and charging the system with the appropriate refrigerant; verifying airflow, condensate drainage, thermostat compatibility, and control wiring; performing system start-up, testing, and commissioning; and restoring all affected surfaces and finishes. All work shall be completed in accordance with applicable codes, manufacturer instructions, and agency standards to provide a fully operational HVAC system. Location: Duchesne Bunkhouse. Period of Performance: 11/16/2026 to 04/02/2027 The work under this contract includes furnishing all labor, materials, equipment, tools, transportation, and incidentals necessary to remove the existing 5-ton air-cooled refrigerant condenser unit and associated indoor coil, and to provide and install a new 2.5-ton air-cooled condenser unit and compatible indoor coil at the Duchesne Bunkhouse. Work shall include, but is not limited to: Disconnecting, recovering, and properly disposing of all refrigerant in accordance with federal and state environmental regulations. o Disconnecting and removing the existing condenser, indoor coil, associated piping, electrical connections, mounting hardware, and any other components required for a complete system removal. o Providing and installing the new 2.5-ton condenser and coil , including all refrigerant piping, line sets, insulation, fittings, mounting pads, vibration isolation, and supports as required. o Making all necessary electrical modifications, including reconnection to existing circuits, installation of new disconnects or breakers if required, and ensuring code-compliant grounding and bonding. o Pressure-testing, evacuating, and charging the new system with the appropriate refrigerant type and quantity, following manufacturer specifications. o Verifying proper airflow, condensate drainage, thermostat compatibility, and control wiring to ensure a fully functional and balanced system. o Performing system start-up, testing, and commissioning to confirm proper operation and to meet manufacturer performance standards. o Restoring and/or repairing all surfaces, penetrations, and finishes affected by the work, leaving the site in clean and workmanlike condition. All work shall be completed in accordance with applicable codes , manufacturer instructions, and agency standards to provide a fully operational and complete HVAC system. Questions shall be submitted via email to adam.koepke@usda.gov and are due no later than November 6th,2026, 1500 MST